Switching

Please refer to this answered topic for more information: https://supportforums.cisco.com/discussion/13159756/migrating-seperate-private-network-without-changing-ips-devices I'm trying to create a layer 2 vlan for scanners on a 192.x.x.x range to mig...

I have a ISR4331 router with a SM-X-ES3-24-P switch module installed in it. Unfortunately, one of my coworkers changed the Baud rate to 115200bps at the boot loader command prompt of the switch module. The switch module was stuck in a booting loop, a...

Hi everyone. I am monitoring a 3064 Nexus chassis with SNMP, and I am always getting "interface discards in" on one of the port channels. However this is normal due to an ACL in place. When I look at PO1 it shows the discards:  RX    37188296587 uni...

Sup Engine is not able to sync each other and standby Sup restart when the active Sup is detach Please let me know the existing IOS is fine and provide the procedure to fix this issue. Switch Model : Cisco C6905-E Sup Engine : VS-SUP-2T-10G         ...

Hi there !!! I am getting ready for CCNP voice & I am facing some issues. I am using GNS3 for practicing in lab environment. It is a very simple lab but I am not getting the issue resolved. Following is my scenario & devices I am using: Cisco Router:...

Dear all, I need your suggestion please.  We have a network LAN with 4 Vlans configured under an L3 switch 3650, under this L3 switch there are 3 L2 switches. To pass to the internet, we must bypass an ASA5510 Cisco firewall. The bandwidth of the ...

--------------------------------------------------------------------------------------------------------- customer's switch, version and image:Switch Ports Model SW Version SW Image Mode ------ ----- ----- ---------- ---------- ---- * 1 56 WS-C3850-4...

Hello! I have 3750x stack (15.0(2)SE7), I configure QoS whit CoS and DSCP going to two queue (1 and 3). But the statistics I see that they ate doing the unused queue output queues enqueued: queue: threshold1 threshold2 threshold3--------------------...

Hi We have a 2960G connected to a server.  Both have negotiated to 1G/FULL.  I am having the server team investigating the server logs for errors, but what we are seeing on the switch is a whole lot of output errors, but NO output drops.  Hardware:  ...

I are experiencing issues where Macbooks are not able to find printers consistently. We have a Linksys SRW2048 and a Linksys SRW224G4P connected together via their gigabit Ethernet uplink ports. We have a TimeWarner cable modem connected to a port on...

Hi, There will be 2 scenario, scenario A and scenario B (as attach) Scenario A We would like to ask on how to connect between HP router (BPL RTR) to Cisco 1841 router. Is it possible? People from outside server need to have connectivity to our serv...