Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Hi All,I was hoping someone could help me with me questions.I need to setup some redundancy for a network. I have Firewall and server experience but not so much with switches.I have;2 internet links2 ASA 5510's2 3750 switchesand some dual homed serve...

A L3 request from a host1 to host2 on the same VLAN, does the request get forwarded to the default gateway at all?Or straight to host2?

opers13 by Level 1
  • 346 Views
  • 2 replies
  • 0 Helpful votes

I came across Multicast config on a 3750G and it has both: ip pim sparse-dense-mode ip cgmpenabled under the SVI.When I do "sh ip cgmp" nothing comes up and actually it's not even supported....I read cgmp was developed for CATOS??thanks

opers13 by Level 1
  • 7350 Views
  • 2 replies
  • 0 Helpful votes

HelloHopefully somone can help me with this annoying issue.In our organisation we have a ASA5510 thats connected to a HP switch with several different vlans and they all work fine.Now I would like to add a new vlan to trunk over to the switch, whats ...

I just got a Cisco 3600 router and was attempting to set it up to my cable modem. I feel a little like a noob asking for help with something as simple as this but I am stuck. I followed Cisco's guide and another guide to check my router's config and ...

Hi Everyone,I'm getting this MALLOCFAIL error and then after a while the switch crashed.%SYS-2-MALLOCFAIL: Memory allocation of 774966538 bytes failed from 0x1B33220, alignment 0  Pool: Processor  Free: 23956224  Cause: Not enough free memory Alterna...

Hi everyone:I just want to make sure I understand how PCs and IP phones connect to an external access switch and how they are configured.Typically, an IP phone has a 3-port internal switch.One port on the internal IP phone switch is configured as an ...

visitor68 by Level 4
  • 1220 Views
  • 5 replies
  • 0 Helpful votes

Hello communityI have a 4506 chassis with a sup2+. This morning, the chassis has power fail (one of his power supply has input power led green on and also output fail red led on). When i do a show power, i have a bad status on this power supply.The c...