Suppose I have two Catalyst 6509 switches in VSSconfigutatoin. I have one point-to-point circuit that comes into port1/1/2 of the active chassis. What happens if the supervisor engine of the active chassis fails?Will the stand-by chassis take over an...
Hi Guys,I have the following network topology (please see attached)Now, if the prefix on the WAN on site 1 192.168.1.x is advertised to the core on site1, the core switch has two EIGRP ASs and redistributes this from AS100 to AS101. (one-way) A coup...
Hi Guys, I have 5x Stacked 3750 switch, Sw1 is the master. What are the impact and safety guidelines from removing 2 non-master switch in Stacked? Or what is the procedure for removing/disjoining switch in stacked?Currently these 2x switches have no ...
Dear Experts,I have found a strange problem in our Network.One Perticular NW segment i.e Production Network has problem of NW slow speed and eventually that goes down. In this case as we remove the Cable from L3 SW ( Cisco 3560 ), the Problem is reso...
All, I have a flash question. I need to format a flash drive. Are these flashes hot swappable? I mean, can I take a flash out of an 1841 and put another one in without powering it off and put another image onto it? Thanks in advance for the help.
I am using the SLM224P and I am unable to getPoE to work with any device. The devices are working on other local PoE switches, and the PoE settings are set to enabled in the web config. Is there another way to check this or could it be a faulty switc...
Doing an assignment where I need to set up a school districts WAN and LANs and I am not very familiar with what would make a router/switch better suited for these situations. Could someone please help me.I have a set up a WAN consisting 27 schools a...
hello i am learning ccna. are u suppopse to connect Xover cables to routers n switches? i did that but nothing wants to connect. i cant ping it. when i put straight through cable, it connects. what am i suppose to do
I'm trying to understand how can the average shaping have a BE parameter? I thought average shaping does no allow for bursting.shape {average | peak} cir [bc] [be] Any help would be greatly appreciated.Thank you,TK
Hi all,I'm trying to bring up the vlan interface without having a host attached. I've created the vlan interface, assigned ports to the vlan. At this point I just want to use a loopback plug to simulate a device being attached to the port and bring...
We are trying to configure ip pim bidir on a catalyst4948 running 1212.2(50)SG, and the only available commands are ip pim bidir-offer-[interval/limit]. I am unable to find any documenation on Cisco.com relating to these two options; everything I fi...
