Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
2870
Views
1
Helpful
1
Replies

Need help getting to rommon prompt on Cat 2950

sklapper1
Level 1
Level 1

‎12-05-2007 09:49 AM - edited ‎03-05-2019 07:50 PM

Hi,

I'm trying to use Hyperterminal to get to the rommon prompt on a cat 2950, but can't seem to do it. I've been using Ctrl-Break, Break, Ctrl-F6-Break. But it keeps loading up without going into rommon. Can anyone please tell me the proper sequence to access rommon with the 2950? Thanks!

Steve

Labels:
0 Helpful
1 Reply 1

keeleym
Level 5
Level 5

‎12-05-2007 11:00 AM

Hi Steve

On the 2950 I think that you press the "Mode" button on the front when you power up the switch.

This should interrupt the boot sequence and leave you at a prompt that looks like

switch:

Have a look here http://www.cisco.com/en/US/products/hw/switches/ps628/products_password_recovery09186a0080094184.shtml

Best Regards,

Michael

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card