Switching

Hope I'm asking this in the right place.I can get a transport-mode IPSec connection going just fine in IPv4. When using the same configuration (with addresses changed appropriately) in IPv6, phase 2 fails and the Cisco debug message is: IPSec policy...

The real question is this. I know turning off STP can be dangerous, but my switch is actually connecting via one cable into the wall. Where it goes from there I'm not sure as I only manage the servers and PCs connected to my switch. One day it stoppe...

Hi,I'm trying to use Hyperterminal to get to the rommon prompt on a cat 2950, but can't seem to do it. I've been using Ctrl-Break, Break, Ctrl-F6-Break. But it keeps loading up without going into rommon. Can anyone please tell me the proper sequenc...

I have configured several DHCP pools from a class C address and created associated interfaces on a 3560G switch. Here is a breakdown...interface Vlan5 ip address 192.168.60.1 255.255.255.224!interface Vlan7 ip address 192.168.60.65 255.255.255.192!in...

We are running port-security on a 3750-48PS-S switch running C3750-ipbasek9-mz.122-25.SEE IOS and we are experiencing a strange problem. We have a data vlan and a voice vlan configured on each port, we then run port-security sticky on each port with...

Hi all, can anyone tell the types of physical interface types we can use for atm ?, also what are the advantages of using atm ?

Hello, I want to configure routers to synchronise with a windows NTP server. I have put the necessary commands But it didn't work ************************** ntp source Ethernet0/0 ntp server 172.17.4.70 ********************* *************************...

HI all!I have one fundamental question. I have 2 switches caatalyst 3750 and 1 server HP Proliant with one network adapter with 2 interfaces. Both these interfaces combined, so I have team on server.Next, I connects that 2 interfaces of server in dif...

Hi all, when we talk about a tagged frame, does this mean either 802.1p tagging or 802.1q tagging ? and will the ethertype be the same for both of these ?

Does the Catalyst 4507R running IOS 12.2(25)EWA4 support GVRP? If so, can someone provide configuration?Thank You

I have 2 2950c-24, one of them keeps sending Loopback packets on all ports? I looked all over in the setup and found no reason whay this one does it..I tested this switch with a FLUKE tool.

Is cef per-destination load balance is two ways?Meaning if I have 2 links between site A and Site B and both are using cef per-destination load balance, will soure-destination pair used for load balance between site A and site B, will be the same as ...