TelePresence and Video Infrastructure

We are planning to implement Cisco VTA in one our branch office, it is connected thro' Wide Area Ethernet link with 1Mbps speed. Already we have applied voice qos. Please note below voice qos config.!class-map match-all CM-VOICECONTROL match ip dscp...

Does anyone know how to disable H.264 video calls from within Callmanager 5.1? Or via a registry setting?I've just deployed 30+ cameras and software, but have now found an issue with our Codian MCU and H.264 - we get 1 way video. The fault seems to b...

I'm having difficulty getting the GW2P module to match the National ISDN signaling from the teleco. I had the teleco tech come on site and verify that NI-1 signal is coming from the teleco. The problem is Cisco does not say if the GW2P is using NI-1 ...

Is there any guide document for the gatekeeper size?280128112821285138xx72xx?Thank in advance..natta

Dear all,just can you plz help me with the wfq cdt?? is it the total number of packets in all queues?? or per queue?? cisco press for the ont exam says per queue, but the offical sutdent guids for qos says for all queus?? so please help, or you can p...

I have a CCME 4.0(1) with VT advantage functioning fine. I also have a separate video conferencing setup functioning fine with Sony's PCS-1 & PCS-TL50 products (IP version). I understand that there is a upgrade for my Sony products to make them ski...

Hi guys,I'm very new to Video Conferencing, so here is my question.We have quite a few sites using Net meeting but it has no CAC, so i wanted to know if it was possible to run a gateway or something on their local router that will talk back to a cent...

Can Telepresence and VT Advantage cameras coexist on the same CM 5.1 cluster?

Has anyone had any success when trying to bond multiple T1s in a 7304? I have a 7304 with a PA-MC-2T3+. I'm trying to bond 2 T1s up using the same config I have had success with on my 3845s. When bonded on the 7304, I get my EIGRP and BGP routing,...

can someone point me in the right direction? I need a Cisco MCS that supports between 100 - 200 IP phones. We need the accounting CDR details of the Call Manager, otherwise we would use Call Manager Express.thanks,

Hello,My customer has about 100 branch offices and is interested in IP telephony solution . Video over ip is a part of requirements . They would like to have a simple way for point-to-point video conferencing (just one session from each branch to t...

HOW MANY LINES CAN BE TERMINATED IN 7985G???

We have a mixed environment with a CCM 5 and an old PBX (ericsson BP250) with a qsig connection.When a videocall between Cisco Phones is forwarded on an Ericsson phone, it is forced to be an audiocall (qsig doesn't support video calls)If it's forwar...

Ahhh Found it....dir /allI have a 3825 router that I have uploaded (via TFTP) a new IOS to twice. But even after the second time when I do a show flash the new IOS file does not show up??So if I try to upload it again, it tells me that this IOS is a...