CUCM Lab enviroment

[c.rodriguezesteban]

Hello, im getting ready to take the CIPT I exam and i installed a CUCM 6.0 on a virtual machine, but i have no clue hot to get to the GUI from the CLI,

I can ping my virtula machine from the host, but i cant access throug the brownser either.

And the book that im following " Implementing Cisco Unified Communications Manager Part 1 CIPT1 Authorized Self Study Guide" doesnt say anything about it.

Can anybody help me ?

Thanks in advance.

Cesar

[Jaime Valencia]

Make sure Tomcat is running, try restarting the service.

Open a web browser and type:

https://IP

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

[c.rodriguezesteban]

That wasnt the problem but it put me on the correct direction, all the services are stoped so im doing a new installation, i was using 30 gb of hard disk i readed that i need 74 is that right?.

Id like to rate, but i cant see how with that link.

thanks

Cesar

[c.rodriguezesteban]

Its ok now, i had the proxy enabled all this time, but thanks anyway