at ap> type the following sequence. Press enter at the end of each line.enCiscoconf tip default-g g.g.g.gint bvi1ip add x.x.x.x m.m.m.mendcop run stAfter you type en and Cisco, the prompt will change to ap#.After typing conf t, the prompt will change...
There is merit to the rumor. Cisco does not recommend performing an IOS conversion on a 12.03T VxWorks AP because of a problem with the flash overwrite. It's possible that the conversion may be successful, but there is a chance of it resulting in a n...
The serial number is attainable through the web and cli interface on both IOS and VxWorks AP's.On IOS it's easiest to telnet in and sh ver. The serial number will be on the second page of the output.In VxWorks, the serial number is visible on the acc...
You have several options here.First, as stated in another reply, you could build a solution around site-to-site VPNs. However, the mobile units may pose somewhat of a challenge with that solution, likely requiring the use of Cisco mobile access route...
