HiReally hoping someone can help with this. I'm trying to setup NATing on a C9300 switch. It's an Advanced license so should be enabled. I'm trying to provide internet access for a guest network so am configuring it in a separate vrf. The config I ha...
Thank you everyone for your help, I ended up getting a 930 ISR as a workaround for the issue but was recently working on a PoC for another project and was using vrfs on a 9300 to simplify the setup and stumbled on the fix. I had (quite embarrassingly...
Hi Thank you, it does require a network-advantage license, we have already bought the upgrade and applied it to the switch: ------------------------------------------------------------------------------Technology-package Technology-packageCurrent Typ...
Thank you. I don't have the match-in-vrf available on the switch. I tried swapping the configs around so the other routing table was in vrf and this one wasn't and had the same issue.
Thanks for this, I don't seam to have the Match-in-vrf command available on the switch so. I tried updating it to 17.11.01 but still can't see the command. So, to check if this was the issue, I moved the other routing config on the switch to it's own...
HiThanks for the reply, show ip nat trans vrf Guests doesn't show any translations until I do a ping vrf Guests 8.8.8.8 source vlan 400. The switch is at a remote site so I left a Webex phone connected to Gi1/0/17 (on vlan 400) so it should be genera...
