hello I just finished a lengthy new install of CUCM 12.0 on ESXI 6.5. getting a 404 not found error on /ccmadmin/showHome.do
any advice to repair the install? i really would not like to repeat this one.
hello - any idea when third party call control firmware will be made available for the 8821. it seems to be available for the other 88xx series models.
Downloads Home > Products > Collaboration Endpoints > IP Phones > IP Phones with Multiplatform ...
hello please advise. i am receiving the following error when updating firmware from 11-0.3SR3-2 to 11-0-3SR6-15 on the cisco 8821.
not using call manager. i am using a local network alternate tftp server following these instructions: https://www....
appreciate that. i am trying to get up to speed on the cli commands.
**edit ssh works fine without additional config .. if you use the correct credentials.
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/cli_ref/12_0_1/cucm_b_cli-refere...
successfully installed CUCM 12.0 on ESXI 6.5. automatically registered the 8821 wireless phone by setting the tftp address to the CUCM server. seems like feature overkill as compared to CME but the server virtualization is priceless.
i am going to try CUCM on ESXI 6.5. if i can find the install media and figure out the licensing. there might be a demo license for 6 months, but it seems one of the best ways is to buy an old ISR like the 881.
https://www.cisco.com/c/dam/en/us/...