Hi everybody,
I have a 3725 with NM-30DM and I'd like to replace it with a 2811 with PDVM2-36DM.
Here you find the 3725 configuration and the new configuration I put in 2811:
3725:
!
card type e1 2
!
modem country mica italy
!
virtual-profile virtual-template 1
isdn switch-type primary-net5
!
controller E1 2/0
pri-group timeslots 1-31
!
interface FastEthernet0/0
ip address 172.17.9.3 255.255.255.240
speed 100
full-duplex
!
interface Serial2/0:15
no ip address
encapsulation ppp
dialer idle-timeout 600
dialer load-threshold 5 outbound
isdn switch-type primary-net5
isdn incoming-voice modem
ppp authentication chap
ppp multilink
ppp multilink load-threshold 5 outbound
!
interface Virtual-Template1
ip unnumbered FastEthernet0/0
peer default ip address pool dialup
ppp authentication chap
ppp multilink
ppp multilink load-threshold 5 outbound
!
interface Group-Async0
description Interface Async Dial-In
ip unnumbered FastEthernet0/0
encapsulation ppp
ip tcp header-compression
dialer in-band
dialer idle-timeout 600
async mode dedicated
peer default ip address pool dialup
ppp authentication pap chap
ppp multilink
group-range 33 62
!
ip local pool dialup 172.17.9.129 172.17.9.254
!
dial-peer cor custom
!
line 33 62
session-timeout 600
script reset cisco
modem Dialin
modem autoconfigure discovery
autocommand ppp
transport preferred none
transport input all
transport output none
autoselect during-login
autoselect ppp
!
2811:
!
card type e1 1
!
modem firmware slot 0 location flash:V3_07.axf
modem country v12 e1-default
!
virtual-profile virtual-template 1
multilink bundle-name authenticated
isdn switch-type primary-net5
!
controller E1 1/0
pri-group timeslots 1-31
!
interface FastEthernet0/0
ip address 172.17.9.4 255.255.255.240
duplex full
speed 100
!
interface Serial1/0:15
description *** ISDN PRI BT Italia ***
no ip address
encapsulation ppp
dialer idle-timeout 600
dialer load-threshold 5 outbound
isdn switch-type primary-net5
isdn incoming-voice modem
ppp authentication chap
ppp multilink
ppp multilink load-threshold 5 outbound
!
interface Virtual-Template1
ip unnumbered FastEthernet0/0
peer default ip address pool dialup
ppp authentication chap
ppp multilink
ppp multilink load-threshold 5 outbound
!
interface Group-Async0
description Interface Async Dial-In
ip unnumbered FastEthernet0/0
encapsulation ppp
ip tcp header-compression
dialer in-band
dialer idle-timeout 600
async mode dedicated
peer default ip address pool dialup
ppp authentication pap chap
ppp multilink
group-range 0/322 0/357
!
ip local pool dialup 172.17.9.129 172.17.9.254
!
line 0/322 0/357
session-timeout 600
modem InOut
modem autoconfigure discovery
autocommand ppp
transport preferred none
transport input all
transport output none
autoselect during-login
autoselect ppp
!
With this configuration the 2811 is unable to receive incoming calls. I tried also to use 'modem country v12 italy' but it didn't work.
What's wrong with the new configuration?
Many thanks
Regards
Stefano
