We have an office in Luxemburg connected to the Internet via a D-Link wireless router. We wanted to replace it with a Cisco 1801w router so we could setup a site-2-site vpn but when I connect the adsl line to the Cisco router the line is coming up. ATM interface status is always showing as down. Is there a different RJ11 cable pairing in Luxemburg or I am I missing something here?
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...