VPN

Good morning from Greece…I am new to this forum and happy to see that I can find people that share their interest in networking… So I need your help-advice-opinion PLEASE give it…I have configured 2 Cisco 876 with an Ipsec tunnel (to communicat...

I have a Cisco ASA 5520 running software version 8.0(4), which serves as an endpoint for quite a few IPSec L2L-tunnels, and as an endpoint for up to 300 simultaneous VPN clients. Most of the clients use Cisco VPN Client, but 64-bit Windows-users - an...

hellowe have hub and spoke MPLS network connecting HO to remote sites.in each site one cisco router (3800 in HO and 1800 in remote) connects the LAN to the MPLS network.we activated IPsec between these routers.it was working fine for some period, the...

Hi everyone,I'm having toruble with a basic configuration DMVPN. The debug ISAKMp shows:06:42:44: ISAKMP (0:61): beginning Main Mode exchange06:42:44: ISAKMP (0:61): sending packet to 64.116.x.x my_port 500 peer_port 500 (I) MM_NO_STATE06:42:54: ISAK...

Hi, I created 1 Site to Site tunnel but 1 of the already created Tunnel has broken up.before creating the tunnelcrypto map VPN 95 ipsec-isakmp! Incompleteafter creating the tunnelcrypto map VPN 60 ipsec-isakmp! Incompletecrypto map VPN 95 ipsec-isakm...

Hi,the dead peer detection with IPsec-Clients works very well on our ASA 5520. In contrary to this, DPD does not work when Anyconnect-Clients lose their SSL-VPN connection (e.g. when their LAN cable is pulled off). Although we set the appropriate set...

Hello I have PIX515 as internet gateway where I configured static NAT to ASAstatic (inside,outside) "public IP" “ASA IP” netmask 255.255.255.255On ASA VPN I set route outside 0.0.0.0 0.0.0.0 192.168.1.1 where 192.168.1.1 is PIXWith that config...

Hi,I have a following configuration:Router AUX port -> FW ConsoleIf there is something problem in the FW I can log the FW from cisco aux but the problem is now that the aux port is sending character's to FW's console port and now if the FW is rebooti...

There is two site with 2801/CallManager Express routers. I need to have LAN-2-LAN connection over Eth WAN interfaces.It is possible to configure two VPN tunnel with redundancy? How to monitor VPN-tunnel state and switch to second tunnel?

Hello, Is it possible to configure WebVPN and Remote Access VPN on the same ASA for the same corporate network at the same time. Thanks.

ASA 5520 (8.2.1), ASDM (6.2)Hi,I'd like to put my own help info in the the right hand pane where the normal Cisco help appears on the Terminal Servers page.Is this possible? I tried using the Help Customization via the SSL configuration ASDM (6.2) wi...

Firstly, apologies if this is in the wrong forum.Last week I had VPN client v3.? installed on a Vista machine. I upgraded to Windows 7 Ultimate which subsequently meant an upgrade to the VPN client.After uninstalling 3.? and installing 5.0.02.0090 I ...

Hi All,how to enable VPN between these router and allow through PIX?Site I :  T1 Router Cisco 1721        Firewall CISCO PIX 506eSite II :  T1 Cisco 1721        Firewall PIX506eSite III:  Bonded T1 Router :CISCO 12651 Firewall: Cisc...