VPN

Hi All,Does anyone have a "step-by-step" guide on how to setup a LAN-to-LAN IPSEC VPN (Dynamic) between a Cisco Router and a Juniper Router?Regards.

Hi All,We've setup a VPN tunnel with a partner through Internet (@Different Country with different Time Zone) using the following guidlines:http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00800b12b5.shtmlWe are pha...

I setup VPN using the wizard and I can connect but I can't get to internal resources. I'm not sure if I need to add a route somewhere but I'm sure this is an easy one but I don't usually focus on Security.

i have a PIX 505 series, and i want to upgrade to ASA 5510 series. the IOS on the PIX is 7.2 version. do i copy and paste the CONFIG of the PIX into the ASA or i have to modify some rules in the CONFIG of the PIX ?thanks

We have setup a site to connect to the ASA with ezvpn and nem, which works fine, but we also want internet based traffic to be in the tunnel then go out through the asa. This means that it arrives encrypted on the same interface as we want to send it...

VPN 4.x Client (IPSEC/UDP) can connect to an IOS router 12.4 and authenticate successfully but can't ping and telnet to devices. This configuration was fully tested in a simulated environment and worked using actual ip addresses and devices to be de...

Hi All,Thanks to everyone that helped me with getting my SOHO 91 VPN IPSEC endpoint working with NAT. I had read probably 100 documents from people with similar problems with IPSEC and NAT with most of those threads ending with no solutions... I ac...

we are using windows L2PTOverIPSec client to setup remote access VPN to ASA5520, once the connection been built up,we did a continous ping to 1 server in our LAN, after around 30 minutes, the connection dropped automatically and we have to connect ag...

We use a cisco vpn concentrator here to allow our staff to work from home over a vpn connection.The situation has come up where one employee needs to work at home for an extended time and I would like to set her up with an VOIP phone. We currently on...

I am setting up a tunnel between an ASA 5505 and an ASA 5540. One of the requirements is that the clients on the ASA 5505 (remote) side connect, they are 802.1x authenticated by an authentication server on the ASA 5540 (local) side.Can the ASA 5505 ...

Is it possible to configure and operate the ASA 5505 as a SSL VPN server and Easy VPN Client at the same time? We would like to configure a few of these without having to purchase additional ASA 5505 and use a 2 device method (1 SSL VPN Server and 1...

Hi,All of my remote sites are connected to HQ via MPLS circuits. I would like to create back link for those remote sites using 871 routers with DSL connection and terminate ipsec vpn tunnels at the outside interface of ASA5540 located at HQ. The 8...

I just found out that we are bringing on two more employees, both of whom will be working from their homes (they live in Los Angeles, CA, home office is in Spokane, WA).We will be putting a local PC and Cisco IP Phone at each of their homes, and trad...

I have configured Remote Access VPN on a PIX 515E running PIX OS 7.2(2). I am able to connect via the Cisco VPN Client, and pass traffic to the Internet but it appears to be U-turned rather than sent to another device for inspection. I have enabled ...