VPN

Hello, Is it possible for a user to choose wheather to accept callback & continoue with server calling the user back, or to cancel callback and continue to be hooked on the network with user initiated call. For instance, when dialing from windows dia...

Hi ZulfikarWe are using rlm protocol betwen sc2000 and cisco as5350. Especially when we terminate huge calls on gateways all outgoing B-channels are turned to "proposed state".Some similar bugs are already defined for different ios releases in cisco ...

Hello,I'm haveing some problems getting dialed in and authenticated to an AS5300 using IAS for a radius server. I know the radius server is working fine because I'm using it for my VTY ports. When I try to set it up for the lines 1-48 I see the bel...

I am trying to setup a IPSec hub at a colo center with multiple locations. The colo center has IOS 12.3 and all remote sites has 12.2. Most of the remote sites are on DHCP. Due to the hardware, 12.3 is not possible and DMVPN is not feasible. What I h...

what does it happend if a service configured to work in an auto mode - but connected with 4-wire, lose one of its 2 pairs?i want to confirm the exact behavior, because i didn't find anything about it. thanks a lot in advance.adriana

can i get a fully url for a sample configuration of vpn betwen ciscoios router to vpn client ?Regards

Hi,that's the PIX 501 configuration:PIX Version 6.3(5) interface ethernet0 auto interface ethernet1 100full nameif ethernet0 outside security0 nameif ethernet1 inside security100 enable password xxxxpasswd xxxxhostname PIX-501-10 domain-name mvi.loca...

I have an EZ vpn set-up between a Pix501 (Server) and an 857 isr (remote) The remote client is set in network extension mode and the connection is made and works well for approx 30 seconds and then fails. It comes up again after about the same time. ...

Hi everybody,I have heard that ASA can support active/active configuration but don’t know about IPSec, SSL VPN, AIP-SSM and CSC-SSM. Does anyone know if they support?Thanks a lot,Nitass

I am testing remote users connecting to an ASA. The syslog shows no xlate being forned. Users cannot connect. Do I need to set up NAT for remote VPN users to the ASA?

Hi to all :I implemented the IPSec router dynamic LAN2LAN peer and VPN client with an 2821 router acting as HUB and 1 Mb bandwith facing to internet Does anyone knows how to assign a specific bandwith for the peers..???LAN2LAN and VPN clients.

I have an ASA 5520 that has VPN configured on it. I have set up the in the DfltGrpPolicy the DNS and WINS ip addresses. I have experienced on several (4+) occasions where the DNS and WINS just disappears from the configuration. I have a VPNgroup po...

Is there any possibility that this will be supported in the future? And what about QoS?

I have some remote users that have Broadband connections. I need to put 3com IP phones in their offices. i have a couple of guys that i connected with my 3005 and 3002 hardware clients. it works fine except these POS 3com phones need multicast to ...