Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

using group name and group password in anyconnect client

Hello. Is it possible to use group name/password from legacy vpn client in cisco anyconnect client ? I checked "VPN XML Reference" from AnyConnect  Administrator Guide and found nothing about it.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

That's right.AnyConnect

That's right.

AnyConnect Secure Mobility Client (VPN Module) can be used to connect to two types of remote access VPN:

1. Full tunnel SSL VPN

2. IKEv2 IPsec VPN.

The legacy VPN client is used only with the older IKEv1 IPsec VPN and you cannot use AnyConnect as the client on that type of VPN.

3 REPLIES
Hall of Fame Super Silver

No. That feature has not been

No. That feature has not been carried forward to AnyConnect.

There are other ways to restrict users and groups to specific profiles.

New Member

Thank you for reply. We have

Thank you for reply. We have a customer that still has an vpn site with these legacy pcf profiles, where group name and password mentioned. Does it mean we cannot use Anyconnect Client to connect to his site ?

Hall of Fame Super Silver

That's right.AnyConnect

That's right.

AnyConnect Secure Mobility Client (VPN Module) can be used to connect to two types of remote access VPN:

1. Full tunnel SSL VPN

2. IKEv2 IPsec VPN.

The legacy VPN client is used only with the older IKEv1 IPsec VPN and you cannot use AnyConnect as the client on that type of VPN.

2052
Views
0
Helpful
3
Replies
CreatePlease to create content