Access point Signal strength

[Maurice Ball]

Could someone please tell me how to configure my WLC 2504 to set the associated access points signal strength to maximum?

[Ashish Chandra · Accepted solution]

You can set maximum power individually on each AP or you can set them globally to Power Level 1 which is the maximum power level by going to:

Wireless > 802.11b/g/n or 802.11 a/n/ac > RRM > Power Level Assignment Method > Fixed 1

[Maurice Ball]

thanks for the help

[Abhishek Abhishek]

Please go through-

Wireless > 802.11b/g/n or 802.11 a/n/ac > RRM > Power Level Assignment Method > Fixed 1

[anderson_araujo1]

I have the same problem I have Access Point Cisco 1602I-T-K9 is set up, but
with a very weak signal, where I set to leave the strongest signal?