Wireless

Cisco WLAN controller model 4402-25 software version 4.2.130.0 has been configured with CDP enabled yet fails to display the CDP neighbor information of the Access Points that are joined to it. I have looked at each AP and CDP is enabled on each of ...

My dorm room has a Cisco Aironet 1250 access point mounted on the wall about three feet away from where I sleep. I am concerned about it transmitting so close to me while I sleep. Things like tumors and brain cancer come to mind. Can anybody comme...

In the WLC, is there a way to turn off SNMP Traps for Signature Detection? When I go to the Management - Trap Controls page, I do not see a place to check/uncheck Signature Detection.

Hi all,can the LWAP 1252 run without a WLC?a BSC1100 will control the access.Thanks,Fred

Currently I am having an ADSL2 connection which I share with four users. The download limit is 16G per month. Is there any way for me to alcate a certain amount per each user? ex: 4G per user

hi,We are using mac address authentication method to access aironet 1200 series. We have added the mac- addrss of the notebooks in the list and given the ssid key in all the notebooks and it is working. But the problem which we are facing is when w...

Looking for suggestions/solutions as to slow wireless throughput. Hospital with a number of wireless laptops and tablets. Users can use applications fine, however, when trying to perform an application upgrade over the wireless - or even just copyi...

Is it possible to have a 1242 connect to a 1242 via the A radio for a bridge and then service clients on the B radio? The ethernet connection is setup on LWAPP. How could i go about doing this or is there some documentation someone could point me in ...

CDP is a layer 2 protocol. Therefore, I have to assume that in a layer 3 routed architecture for a WLAN controller that the CDP information is tunneled back to the controller. What would cause the controller to NOT have accurate CDP information abo...

My customer is running a guest access vlan and is being directed to a firewall. He says the FW is set to not handle packet size over 1500.Is there a way to adjust the packet size on the LWAPP side to limit it to 1500?

I have a number of 1242AG's installed in a factory, and one of which will not operate properly, as it is on a girder about 20m high, I cannot see which LED, but either the ethernet or radio LED is red, and the status LED is green. This occurs about ...

CDP is a layer 2 protocol. Therefore, I have to assume that in a layer 3 routed architecture for a WLAN controller that the CDP information is tunneled back to the controller. What would cause the controller to NOT have accurate CDP information abo...

I consider upgrading the software on our 4400 from 5.0.148 to 5.1.151, but when I look in the help on Downloading file to the controller, it says:"The controller downloads and installs the new controller Operating System software. This process takes ...