Wireless

I've got a 1240-AG (AP1)configured as a root bridge+clients, and other 1240 AG (AP2)configured as non-rootbridge+clients associated to it.Now, I need to extend the footprint in other bulding closed to the (AP2).The question is, Can I assiciated other...

Hi,I've a network with a lot of 7921 ip phone ( 1.1.1 or 1.0.5 firmware ).I've noticied that a lot of times an ip-phone near and access-point keep the association with another far away AP, with a poor signal.Any suggest ? Is there some best practice...

I've been looking through a lot of Cisco documentation, but I can't seem to find a clear-cut answer.How do I encrypt traffic between two 1310 bridges using WPA2?THanks

I understand there are some issues with some versions of code not working with the 1252 and N. Can some one clarrify this please. I'm not permiteed to run the latest code and that normally means that I have to run 2 revs back. currently I'm running...

Hi guys,I have 8 remote sites and i want to connect them to a central site. My question is: In this type of installation, i mean point to multipoint, all the remotes sites must be in the same channel? If no then i will use the 3 non-overlapped channe...

I am configuring a guest access solution with multiple guest access gateways associated with a single VLAN. Each gateway will have its own /24 network, and obviously it own gateway. The interface configuration page requires a single gateway in the IP...

We have 2 new AIR-AP1210 acces points and we try to configure them. Everything works, but the signal is very poor. Even if the accespoint is near my notebook (1m). We leave the config very basic so i dont understand why the signal is so poor in it's ...

I have 5 units of Lightweight AP1130 and they keep rebooting every 15 sec (seen from console). It query my DHCP server and straight away drop out and reboot. From my DHCP server, I could see DHCP request and release.Since the AP is inline power, I co...

Hi, I'm trying to setup a WLC 4404 with 1131 Light weight APs. I used the internal DHCP of the controller for the APs. and put in on lets say VLAN3. then I have a DHCP server on native VLAN. Now I want my wireless clients to get the DHCP from my exte...

Hi Guys, I have problem for EAP-TLS.I have environment with AP 1121,ACS 4.2(0) Build 124 Trial,AD Replication,Enterprise CA Server,Client Windows XP install Certificate. Wireless Authecation type PEAP,EAP-TLSProblem: User on AD can authentication PEA...

I was running 4.2.130 on my inside controllers, and hadn't yet upgraded my Guest/DMZ Anchor controller to 130 yet, it was running 4.2.99.I upgraded the ER to .112 as recommended and then the controller to 4.2.130 and DHCP responses were then getting ...

Is there a way to run a report that specifies exactly how many 'Clients Per AP' were in use for a particular event. I was able to run a report on TOTAL client count which displayed a graph but thats not what I need. The event occured June 10, 08? I a...

Hello all,so as the Cisco RRM document states :"The TPC algorithm is only responsible for turning power levels down"but on the calculation criteria, it says "If Tx power needs to be increased: TPC hysteresis of 3dBm must be met"http://www.cisco.com/e...

Hi there,I receive this Warning message in WLC version 5.0:Warning: Our AP with Base Radio MAC 00:1f:6d:b9:48:d0 is under attack (contained) by another AP on radio type 802.11b/gSo, what does it means? Can someone explain..Great Thanks.