Wireless

Hi, I really dont know if this issue is applicable here but I am desperate for help now. We have a wireless project providing internet access in a very remote location. There are wireless mesh accesspoints connected back to back by wireless Point2Mul...

Sucks. Website support is so convoluted, it leaves one going round and round in circles. Just trying to find out if my AP firmware needs updating or not is impossible. Then when I feel I'm getting close to finding the firmware, I'm given a choice o...

is it possible to run multiple ssids on an 1242 with different encryption. ie. one will use wep the other is a radius client that uses wpa2

i have a 1200 that i tried to switch to IOS. the reflash started and seemed to go for a few minutes and then an error message. something about reset in 10 secs? now i get all three leds solid green. if i try mode reset switch it cycles through or...

is there a way to replicated access-list to multiple waps instead of logging into each one indivdually.

Hi,Is there way to configure AP 1010 over a WAN. I have WLC4402 (ver 4.0.179.11) at central location. I came to know from cisco document only 1030 and above will support REAP for WAN Support.Please help.Karuna

Good Day,We recently installed a 2106 controller and 1130 access points. This question regards the maximum number of users for a given user name.We host events with up to 100 users. Ideally, we would issue one user name and password for the group. I ...

Hi,If I have all my users going through Dynamic Interfaces (ie. not Mgmt i/f) and these users are the only IP devices using DHCP (APs have Static IP addresses configured) then is the Mgmt i/f DHCP server IP address which the WLC inital setup dialog a...

I have multiple AP's in an arena enviornment. Now without violating the rule where an AP is assigned a non-overlapping channel, what is best practice if there are neighboring AP's within close proximity of each other and they are assigned the same ch...

I just got six 521 AP's. If I plug the laptop to the Console port, I see errors reading the flash image. I have tried this on two of the six. The CCA software does not see these units either. Any ideas? Where can one get technical level info. on...

Hi,On a WLSM with about 60 x 1231 APs.I login to AP & observe the output of this command,sh dot11 associations all-clientFor some clients "Key Mgmt type" is shown as WPAv2-CP and for other clients as WPAv2.What's the difference & what does CP mean?Go...

HI,i have a 4404 Controler and when it boots i get the error message,Bad data CRC, i upgraded to OS 4-0-219-0 then 4-1-185-0 but now im getting the messagebzImage Image Integrity Check Failed (Bad Data CRC). Hanginganything that i can do ?ThanksDan

We use WiSM 4.1.185.0 and sometimes we see following messages on the controller console:Msg 'LRAD Entry set' of LRAD Table failed, Id = 0x0012c2a8 error value = 0xfffffffcMsg 'Set Multicast Params' of System Table failed, Id = 0x0057c2a8 error value ...

I am constantly being asked about 802.11n, there isn't a day that goes by when I am in front of a customer talking about wireless and the topic of “n” comes up. I do pretty good on talking about the architecture, but lately I have been getting a ...