02-15-2012 11:26 PM - edited 07-03-2021 09:35 PM
HI,
I went through below link
http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008073c723.shtml
I have the same setup except the dhcp.
I have dhcp server which is givng IP to clients; I want to divide clients as bulding 1 and building 2 with vlan
But they should get IP from same dhcp server
how can I do it?
02-15-2012 11:39 PM
Have you created ap-group per building and did interface over-ride
Thanks
NikhiL
02-15-2012 11:54 PM
what is interface override???
I have lag enabled on wlc
02-16-2012 12:58 AM
Configure it like this
Create AP-Groups in the WLC for each of the building
Create dynamic interfaces for each building
Under WLAN>Ap-Groups, add each AP in each building, in the respective AP-Groups
Map the WLAN to the AP-groups to the interface for each building ( you can see an option, Add interface mapping in the document you sent)
Thanks
NikhiL
02-16-2012 01:32 AM
what about the vlan,
i need to configure vlan 4000 and 4001
first buldng aps will be in vlan 4000 and second bldng will be in 4001
right now i have only 4001 enabled
02-16-2012 01:37 AM
Create VLAN 4000 also and configure the AP port in VLAN 4000. If you want the client to get ip address in vlan 4000, create a dynamic interface in the WLC in vlan 4000 and map it to the WLAN
Thanks
NikhiL
02-16-2012 08:34 AM
This is a very useful Link on VLAN's:
http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00805e7a24.shtml
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide