Welcome to the Community!
The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally.
New Here? Click here to learn more and get started.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1935112members
1257644discussions

Community Activity

How to Speak Someone on 𝗟𝐮𝐟𝐭𝐡𝐚𝐧𝐬𝐚 𝐀𝐢𝐫𝐥𝐢𝐧𝐞s?

Yes, 헟퐮퐟퐭퐡퐚퐧퐬퐚 퐀퐢퐫퐥퐢퐧퐞 customer support is available 24/7. Whether you have urgent inquiries or need assistance with your travel plans, you can reach out to their dedicated team at any time by calling 【ퟭ-ퟴퟱퟱ-ퟳퟯퟴ-ퟰퟰퟴퟭ】 (USA) or +ퟭ(ퟴퟱퟱ)ퟳퟯퟴ-ퟰퟰퟴퟭ (USA)}....

Switch Cisco Catalyst 3850 SSH

Bonjour c'est Olivier, je suis novice dans le domaine et j'ai besoin d'aide pour mon switch Cisco Catalyst 3850-24P-L. Depuis que j'ai fait la dernière mise à jour, je n'ai plus accès au Web UI depuis mon navigateur chrome. Dès que je tape l'adresse ...

Cisco 9300 switch doesn't connect via SSH

I have a couple of switches that are trunked via a LAN cable from another switch. I noticed that these switches sometimes have a hard time to SSH into. I get the error: "Connection timed out". After a while and a few tries I can connect just fine. I ...

Rick001 by Level 1
  • 365 Views
  • 8 replies
  • 0 Helpful votes

Mobility Expressの内部DHCP

AIR-AP3802E-Q-K9のMobility Expressについて伺います。有線LAN側は固定IPアドレスで使用しており、内部DHCPのアドレスは無線のみに配布させ、有線LANには配布しないよう分離したいのですが、このあたりを教えてください。DHCPプールの「管理ネットワーク」を有効にすると、有線・無線とも無差別に内部DHCPからIPアドレスが配布されてしまいます。宜しくお願いします。

wasiwasi by Level 1
  • 62 Views
  • 2 replies
  • 0 Helpful votes

Mobility Express Internal DHCP

Let me ask a question about AIR-AP3802E-Q-K9's Mobility Express.Currently, I am using a fixed IP address for the wired LAN side, I would like to set it up so that the internal DHCP addresses are distributed to wireless only, and separated so that the...

Translator by Community Manager
  • 48 Views
  • 2 replies
  • 0 Helpful votes

packetfence Captive portal issue

Hi ,I have configured the packetfence according to guide , but when i go to connect the SSID. its directly connect and reach the internet and not redirected toward web auth page.i cant find any logs and anything else to troubleshoot. pls check my con...

Router update issue 4431

Good afternoon everyone.I need help, I'm trying to update my ISR4431/K9 router and I'm failing.The original firmware version installed on this router is: isr4400-universalk9.03.16.04b.S.155-3.S4b-ext.SPA.bin, which is a very old version.My task is to...

sigcerder by Level 1
  • 36 Views
  • 2 replies
  • 0 Helpful votes

mDNS debugging Catalyst 9800-40 with IOS-XE 17.9

How is mDNS done correctly on Catalyst 9800 hardware platforms with IOS-XE 17.9.5. We have to troubleshoot Airprint devices that ware visible with mDNS bridging and not visible with mDNS gateway enabled. Other devices like Airplay are vsibble. From s...

Wsa with radware load balancer

Hi anyone using radware as loadbalancer for wsa? Do we need to change anything in wsa side? We have given radware LB vip in the proxy settings of users but request is not reaching WSA.anyguide is available for the configurations. 

DK9 by Level 1
  • 157 Views
  • 6 replies
  • 0 Helpful votes

MPLS-TE tunnel

Hi ,I am seeing MPLS TE Tunnel is not coming up in my setup. I am using XRV node running version 7.11.2.  I have explained below the config and status.Could anyone please check and comment on this issue ?   XRV-A Config:                              ...

mailatgk_0-1715184319026.png
mailatgk by Level 1
  • 69 Views
  • 2 replies
  • 0 Helpful votes

Circuit diagram for WS-C2960L-16TS-LL

Dear CISCO community,this is probably very rare question, and most likely I'll got negative response, but nothing to lose by asking. I found WS-C2960L-16TS-LL switch forgotten in basement, and it is damaged ( not working at all ) by water/humidity da...