The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
Hello Folks, I am doing Webex Connect Flows Lab. I have created Demo Account. I am not able to Make Flow Live. Getting Error "Sender Id is not configured." in SMS Channel. In SMS Channel Settings From Number is selected as "CONNCT". In Number con...
I have a SPA122 supporting my home and business lines. Recently I have been experiencing problems with loss of connectivity during phone calls. This is unpredictable and I recently observed the lights on the SPA122 indicating a network disconnect w...
Hi! We are going to migrate network devices from old to new ise deployment. would it be alright to register the devices to both ise then remove them to old ise once everything is good on the new one? or is it better if remove the old ise first to the...
trying to migrate our ISE nodes to 3.2 version in a VM-based infrastructure, I am trying to boot VMs into the ise-3.2.0.542a.SPA.x86_64.iso image as obtained from Cisco's software download center but I keep getting the attached error. It is worth no...
hi Cisco,I am using below topology in my lab where ASA in multiple context - C1 and C2 sharing the same physical interface, in different VLANs (sub interface) is not able to establish EIGRP neighborship with 2 cisco routers (point to point). Although...
I need to enable fips remotely the solution is to follow the below steps: Enable fips N9K N9k-Switch# conf t N9k-Switch(config)# no feature ssh N9k-Switch(config)# no ssh key rsa N9k-Switch(config)# ssh key rsa 2048 N9k-Switch(config)# feature ssh N...
Because of the release date (and EoL date) of this old version of the ASA, I am struggling to obtain the original checksum that Cisco would have provided on this file. Would anyone have the hash of this file so that I can compare with a file I have ...
Hi~ I am studying ISE. I'm going to try installing it first. I understand that there are three essential elements: NTP, DHCP, and certificate. Is this correct? (Certificate means "selfsigned certificate" or "certificate issued by CA")
Hi all, my customer has added IPv6 to their BYOD WLAN subnet and are seeing the following log messages on their Cat6k syslog %IPV6_ND-6-DUPLICATE_INFO: DAD attempt detected for FE80:: on VlanABC%IPV6_ND-6-DUPLICATE_INFO: DAD attempt detected for FE...
We recently got several VG320 and VG310 and just deployed but I see the link these hardware are expired.End-of-Sale and End-of-Life Announcement for the Cisco Voice Gateway VG320-EM and VG310-EMAre VG320-EM and VG320 are the same hardware and already...
Hello,just wanted know the below mention error on Cisco -4331 router%CRYPTO_ENGINE-4-CSDL_COMPLIANCE_RSA_WEAK_KEYS: RSA keypair Is there a cause and solution?
I got an stack with two C9200. One C9200-24P-E, and one C9200-48T-E.This stack runs in install-mode, with software version 17.03.03. The two flash: are as following : Switch#dir flash-1:Directory of flash-1:/72892 -rw- 2097152 Sep 30 2021 08:07:04 +0...
Is it possible to recover a password from RV345 without a factory reset? As far as I can tell our password was updated when it last expired but wasn't updated in any documentation we have.