i have read in the WAE manual that all 3 devices must have the same software version. what will happend if the 3 device have different versions?exp.Core & Edge = 4.0.13.b.12 CM = 4.0.13.b.23 rgds,ben
I have my ACE blade (running A1(4d) ) currently set-up to static nat to an FTP server.I have tried setting up a sticky SLB VIP for FTP across this server and an additional box but firewall in front of the ACE throws the connections.It appears that th...
The second context is not working, config is auto-sync'd - Nothing is appearing in the arp table, so no communication is being made to the context. This sounds like how it should work when it is in a secondary state, is this the case?But when I failo...
i have 4.0.13 &enterprize license for my waes & central manger for c.m wae now i'm see update software option i want to ask 1.if my licence allow me to upgrade my ios or just GUI interface ?2. is that upgrate is for free (after i had license) 3.ask a...
Hi, we have a stack of switches (L3) when connected the internal LAN and DMZ, two ASA5510 in Active/Standby mode and a 2811 router.We want to put the WAE512 in the inside side of Firewalls managing the traffic of interlan LAN and DMZ, because as we f...
Hi -So we are exploring ways to implement WAAS in our network and our connection into our WAN contains two PIX firewalls in Active/Standby mode with a connection to a single 3560 switch.I understand WAAS can do failover when connected in a daisychain...
Hi,I am in the process of setting up Cisco WAE running WAAS 4.0. One WAE will be in the branch and the other in the HQ data center.My question is, is it a MUST that I have a separate WAE running as a Central Manager?
Hello,I've a problem with my Content Switch, hope you'll be able to help me to solve it! So there are 2 content switches (master and backup).As expected, they are used to balance connections between servers in a farm. Several balanced sites are using...
Hi,We are using the CSM blade in bridge mode (or daring to do so).We had a problem with the blade some time ago, the blade stopping to forward traffic from the client vlan to the server vlan without any error...This w-e we had the same problem and ad...
My LB is dropping connections on port 443 when I have "insert-http source header-value "%is" configured. Other ports such as 80, or 8080 are working. The config is the same for all ports. class-map match-any Service_VIP_Class 4 match virtual-address...
Preempt is not working - It is configured as default on primary and disabled on secondary, it appears correctly in sh ft group x detailThe failover appears to work as far as FT is concerned.The two start out asPrimary:My State : F...
Is transparent NAT possible? The applications need to be aware of the source IP address to process. The only way I can see to do this is insert the source into the header. I seem to recall reading about transparent NAT, and no NAT, but I cannot find ...
Trying to figure out how to configure SNMP access to servers located behind a CSS running v5.02003.It looks like in v6+ flow-state flow-enable needs to be configured, but in v5, I don't see this command.Does anyone know if the command isn't required ...
Dear All, I have just inheirted a pair of two legged (bridged) CSS11506 (software version 07.50.1.03). My goal is to enable ip communication between two vlans ( Vlan X [172.25.2.0/24] , and Vlan Y[192.168.34.0/24] where CSS sits). The question...