Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
HiI have to make sure the existing firmware of the IP phones will be compatible after the upgrade of the call manager from 4.2 to 6.1when I check the device default configuration on the call manager, the load information indicate "P00308000400".I am ...
How to dedicate specific B channels (PRI)for a specific service.i.e how do i dedicate the first 15 B channels for In-only and the second 8 B channels for Out-only in 2821 Integrated VOICE Gateway Router.
Has anyone gone from 6.01 to 6.13 via 6.11 and experienced any major issues or items that i should look out for while doing the upgrade?.
Two 7961G Phones are stuck and neither upgrading nor booting up. Following message is logged on the RS232 Console:#######################################CNU 3.1(1.15); Mar 21 2006 21:51:25Copyright (c) 2001-2005 Cisco Systems, Inc. All rights reser...
Hi There,I'm planning to do the upgrade to CUCM 7.0.2. We currently run a cluster with CUCM 6.1.2 on two MCS7825 H3 servers, pub and sub. The main feature that we are looking to use is dual forking with Remote destinations.I'm planning to do it first...
Users cannot put someone on hold if it isan external call.Hold works fine internally. Please help.Thanks.
Hi all,I am working on one AS54000 to deploy several IVR scripts. Since I need tone generator and transcoding I am using 2 T1 interface ports connected with loopback cable. The call comes to the gateway and goes to the T1, then comes back to the gate...
Greetings,I know that using route lists allows having redundancy when a first H323 gateway in the route list has all its local voice ports being busy. That works fine.I'd like to provide the same redundancy mechanism when all remote voice ports are b...
Hi. I want to know how to configure multiple mail box for single user in cisco unity connection. pls help me how to do it. regards Esa
We are upgrading from CCM 4.2 to 6.1 on new hardware. I believe the export information sent from 4.2 to 6.1 does not contain address book or fast dial information. Is this true? If so is there a method of getting this information into 6.1 other than ...
Is there a place on cisco.com to check if a particular patch/rollup is considered stable in a Unified VM environment. In my case, the Exchange Server is separate from Unity, but I don't want to break anything or cause issues when applying patches to ...
Hi team How Can I configure DDI for CCMEMy DDI Range 2303320-29and me Phone Number 501 -509Brgds
Do I neeed to request a new feature license going from CallManager 6.1(2) to 7.0(2)? We do have UCSS.I downloaded UCSInstall_UCOS_7.0.2.10000-18.sgn.iso and the release notes indicate yes I need to request a license.
I have six GS analog trunks connected to 2 4FXO cards in a 3825. The inbound calls work fine, anything outbound cycles through all 6 circuits and eventually I get a fast busy. I set them up the way I've set them up on every other install I've ever do...
Hi Guys,I trying connect in the CCM with my Customer but don't work. The Customery enable port 8443. There are another port that my Customer need enable?Thanks,Wilson Santana
