Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
We have an AVST CallXpress voicemail system and when we dial the number to access our mailbox, the # and * doesn't register as being pressed.Has anyone ran into this issue with CUPC? Or is this an issue with CallXpress?Thanks.
Hi,In the Webdialer documentation I have seen reference to a plug-in for Outlook that allows stored contacts to be called using Webdialer.Does anyone know where this plug-in may be obtained? Do Cisco or Microsoft do something or is a third party appl...
There are three kinds of devices register to gatekeeper, one is Cisco router with voice interface(R003V), one is Cisco router running CME(R071V) and and the other is CCM. I want to add a new Cisco voice gateway with zone prefix 3086* but fail. I got ...
CM version 4.3I am trying to connect a billing server to callmanager CDR table. I have set the security on the DB to mixed mode. Created an account on CM with access to the CDR table but when I try and create a system dsn on billing server I get the ...
is there a way to differentiate between internal and external calls. e.g. can you change the ring tones?
I have a telephone joined a PBX across a tunnel between two ATA 186 (H323).The connection is across analogical line, and the position of interception is an autoatendan.The problem is that when I order the tones MF for the different options of the aut...
At site #1 we have a CUCM and a Voice Gateway, the gateway is a 2811 and is acting as the voice gateway as well as the VPN/Internet termination device. The tunnel to the remote sites is created from that 2811.At site #2 there is a 2651XM terminating...
Hi Guys, I'm trying to get my CME 7.0 system users to dial a non DN 4 digit extension and have that translated to a 7-10 digit extension. Like a customer wants to dial one of their employees that works via cell phone. They want to dial a 4 digit ...
I am going to deploy UCM 6.1(2) to SIP Carrier Provider. This solution will have an CUBE between UCM and SIP Provider. Dose any have the configuration hint /sample
I have configured Mobility for Single Number reach and I am having just one issue. The issue is that when I call a users desk phone, after 4 seconds the desk phone stops ringing and then rings on the cell phone. Is there any way to keep the desk ph...
HiWe have a 2811 with CME on with 12.4.15 code on and two ISDN BRI lines. The problem we are experiencing is that outgoing calls are intermitantly working. This is not due to load as I'm the only one on these lines. I can use all four lines if I'm...
Hi,Has anyone got mobile voice access working with a H323 gateway. I have configured it, but when I ring the DDI, the call hits the gateway and drops. I have attached my config below. My mobile voice access number is 53842 and the DDI is 9842dial-pee...
Dear friends My company is like to migrate to VoIP. My requirements are 6 fxo ports for local loop from C.O Call manager supporting 30 ip phone gateway ivr suppot, voice mail support, call recording support, billing support 25 ip ph...
I am configuring annunciator. Locally for the ip phones when i block any route pattern i get a message from the ccm based on the reason. But when i dial the same number form PSTN i am not getting the message. Is there any way to solve this issue. By ...
In VoiceGateway,I have 2FXO with 4 Analog Phones.I want Phone1 & Phone2 go through fxo1 for outbound, and Phone 3 & Phone 4 through fxo2 for outbound call.How to make it?
