Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
One of our users was in concall (he was taken in concall by other party). His call was dropped and the error was displayed as "CM down Features disabled". On Cisco site, they stated that this error comes while making calls. But we saw it immediately ...
I have a problem which appears to be impossible. Set up customer to work in U.S. goes to Zurich can web in to give credentials but phone merely sits in registration state.
Hi, We have Unity 4.0(5.) in our environment. We have licenses for 50 users and 16 ports. We have installed unity on Dell machine. We need to know how many more licenses can we purchase? (what is the max capacity of Unity 4.0(5)) and from where to ob...
Hello Everyone,Does anyone know if there is a way to gather all the serial numbers for phones in a report using Call Manager 5 or above only and not any third party tools?Thanks in advance! All replies rates
I recently did a version upgrade from 6.1.1 to 6.1.2. When I did the "switch version" and made the inactive partition the active partition, all the phones reverted back to a previous configuration. Is there a way to make these partitions sync so ther...
Hi All,Has anyone tried to install Cisco Unified CallManager Device Package 4.1(78.0) (ciscocm.4-1-DevPack-78.exe)? I've tried downloading it a few times, the MD5 sums match what is on Cisco's web site, but i'm unable to install it. Have tried on s...
Hi, I've got a 2811 with 3 E1 voice cards. Each voice cards, has got 2 ports. Each port is connected to different telco. The gateway is operating in H323 mode. I can receive incoming calls perfectly fine, and also make outbound calls. Occasionally,...
I have a new region setup on my call manager where I am setting phones from a branch. In the event that the local PRI goes would like to reroute calls out my HQ gateway. The HQ gateway is H323 and works with outbound calls from our default regions....
one of our remote sites can't dial valid 509 number which worked on other sites.Debug isdn q931 and we got:Cause i = 0x8081 - Unallocated/unassigned number Any idear what's going on? Thanks.
as the title says, can you remotely gain access to the command line on the 6.1.2 linux platform.ta
Hello,I have a two node CCM 4x cluster. How do I change the active call manager server? I'm having trouble finding any reference to it in the documentation.Many thanks in advance.
Can anybody tell me the maximum length of telephone cable that can run from the ATA device to the analog phone? we need to give an extension to the security point about 100 m away outside the building. fiber is costly though protect from lightning. s...
Does CME 3.3 support the 7941? I can't seem to find the firmware download for this.-Shikamaru
Is there a softkey or anything similair I can use to make my phone appear off hook? I would like to use this feature to exempt my phones from my hunt group.
Hi folks,I'm trying to get my head around the command...switchport voice vlan dot1pHere's what I think I understand...The device and the IP phone use the same subnet.The phone uses VLAN0The Device uses Native VLAN of switchportThe phone and device ca...
