Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I have two routers configured with CCME, when i set in the main router the codec g729br8 and the branch router the codec g729br8,,the communication failed. Busy tone. But when is set in the both router the codec g711ulaw, it does work. How can i conf...
I'm guessing the answer is NO, that CME only supports SIP trunking. Can someone tell me otherwise?
f a 3550/3750 switch is not qos enabled and IP phone connects to it. How does it happen when packets arrive on the outbound interface to wan(dot1q between them): 1. dscp reserved? 2. how about cos? since no qos enabled, switch won't look at the defau...
I was wondering if there is a bulk delete for domino on unityi know that there is one for exchange.any users run into issues that needed such a tool?
Where can I go to verify the checksum of the DVD that shipped w/ the ccm 5.1 server? Anyone have the link?- thx
My Call Manager Express 2801 is connected to a Catalyst on vlan 20; dhcp server is on vlan 10; if I plug the phone on the same vlan with 2801, it registers fine; if it's from a different vlan, the phone cannot register.with "debug ccsip messages", I ...
Hello,just recieved (2) new ibm 7835-I2 servers running callmanager 5.1.1 and when I start them up they stop at the "Welcome to Cisco Unified CallManager 5.1.1.3000-5" prompt. Has anyone experienced this before? Your input would be appreciated. - ...
Hi allWe run a Callmanager 4.2(3).When I install the local files (German / French / Italien) I basically don'tneed to install the Network Local File?Ist that true?Thanks for helpReto
My client has CCME4 set up for 2 departments. they want all outgoing calls from department B use certain PSTN lines, like FXO 1/0/0, 1/0/1. instead of automatic selection. how to set this up?
Currently users behind a 2621 router with a t1 connection to the hub site in which they use that t1 to gain network acess, internet and voip. That t1 keeps dropping. I am investigating with ISP. As usual, they have me always doughting and thinking...
I would like to know whether AAR is used to reroute the calls through PSTN if WAN is congested or even if WAN link fails ? Because I have a centralized CCM running at HO,and Branch with SRST enabled. I guess translation pattern might help me at rem...
can this user account be locked down for access one particular call searching space?
HiI have just configured a CCM 4.2(3) system with an ICT to a CCME4.0 system.I can place a call from the callmanger to a CCME extension and it rings and displays name but when it is answered i get reorder tone back and the call is cleared. I used sug...
I would like to ask how to set qos in Catalyst 4500?
Hello all,I have a problem with my ATA, i can't send and recieve with.The ATA have the H323 firmware and i would to back to SCCP firmware.Any one can help me.best regards
