MPLS

I have a MPLS VPN network and on one of the 7200 routers which is one hop away from the edge, I have an MPLS entry which says "Recursive Paths" (see below). What does recursive path means? How is the next hop information found in this case? 133      ...

We have an MPLS network with 50 sites. Each site has a 10mb connection into the MPLS cloud. Naturally, there is only one route out of the network to the internet and once again ingress & egress on this is 10mb.We can see that this part of the network...

Hello Folks,Today during my technical discussions with one of my colleagues I found an interesting question posed by him, He asked me is there any specific reason to disable PHP?I am keen to know this, Please answer if any one has a reason? I frankly...

I have a simple ring network with 4 3600Xs with IP/MPLS 10 gig backbone between all units (with OSPF running in the core).  Per the 3600 design guide I turned on IPFRR under OSPF for fast reroute of traffic around faults.  I have a l3vpn on the 3600s...

hey everybodyi know that LSP without vpn MPLS   , is performed  like that :CUST1 (10.10.10.1)  ---PE1 ----P ------P ----PE2 ----- CUST2 (20.20.20.2)PE2 assigned a label (L1) to FEC 20.20.20.2 and sent at P this last receive (L1) and swap it to P with...

HI     plz guide me . I am working in a HeadOffice  of an organisation. having HUB-SPOKE network topology having several branches in remote area. MPLS VPN Link is given by the ISP. . i have put on symatice server inside the organisation having differ...

hey everybody i know that LSP without vpn MPLS   , is performed  like that :CUST1 (10.10.10.1)  ---PE1 ----P ------P ----PE2 ----- CUST2 (20.20.20.2)PE2 assigned a label (L1) to FEC 20.20.20.2 and sent at P this last receive (L1) and swap it to P wit...

ParticularModelQty RequiredSOWRemarks1Cisco RouterCisco 2911 Router2-Need to configure dual ISP for ILL and MPLS both-Both ISP’s bandwidth will utilized at same time for its better utilization (e.g. both IPS’s having 10-10 MBPS, then we should be abl...

hey everybodyi have some question about MPLS : in R2 LFIB  i don't understand the fields : Aggregate Untagged  Pop tag  Local  Outgoing    Prefix                           Bytes tag  Outgoing   Next Hop 16     Aggregate    10.10.24.0/29[V] 18     Unt...

Can some help me list Cisco routers and requirements for MPLS on the branch (client) side. We are trying to join an MPLS network from our branch and we are not sure of specific cisco routers to buy

Hello alli have 2 ASR 9000 acting as P routers connected to PEs in different remote locations.access switch ------ PE router 1 ------DSW switch -------ASR 9k (P router)--------PE router in remote locations both PE 1 and ASR 9k are in the same locatio...

Hi Team ,I'm facing difficulty in understanding the difference between MPLS QoS pipe mode versus short pipe mode . Even though following some Cisco documentation not able to see them different !!! What main idea I know is that both agree on receiving...

HiI want to Config  VPLS Network on 7600 Routers But i dont know how many ES+ card i need and i dont know where i should install this cardsthank You so much