MPLS

i am looking for the document which can overview about the qos for csc network or inter-as.regardsshivlu

I offer four classes of Internet bandwidth to my customers (256kbps, 512Kbps, 1Mbps and 2Mbps), but presently we want to introduce VOD service which require 4mbps on bandwidth. The VOD server is residing on my network, how can I provide the VOD servi...

hi, i confuse about mpls mtu command test platforms are 76 pfc3b,mpls,gigabit sip400 spa interface if i didn't config mpls mtu command ,using default,ping command is successful,if more than 1496 packets, i can see fragment from show ip traffic...

Hi all,I have a situation whereby I would require to configure a taildrop behavior for queue2. The CoS mapping are as follows:interface GigabitEthernet5/1wrr-queue cos-map 2 1 4 !CoS 4>Q2 Low priority/Threshold#1wrr-queue cos-map 2 2 6 7 !CoS 6,7>Q2...

Is it possible to carry clear channel E1 (G703 IPLC) over MPLS network. The E1 is meant to carry mobile operators voice and signaling. I don't want to packetize the E1 using media gateway or other means.

I am working through an MPLS network that doesn't support VPLS. I have a question related to how I can bridge VLANs between two sites using my switches connected to the providers MPLS network. I believe that DLSw will be able to bridge the traffic on...

Hi,I do have topology CE8-PE2(AS 65001)-PE1(AS 65001)-ASBR1(AS1).Now PE2 and PE1 both are in same AS and PE1 has ebgp with ASBR1, ASBR1 is my internet router. I do have vrf ce on router PE2 and have attached that vrf on PE2 interface where CE8 is con...

The command "mpls mtu " is used to set the MPLS MTU value higher than the interface MTU value . But I also see the note " Although you can set the MPLS MTU to a value greater than the interface MTU, set the MPLS MTU less than or equal to the interfac...

hi freindsfirst im a newbie for MPLS.I have a simple network , as followsCE-PE1-P1-P2-PE2-CE.I have a problem with this scenario that CE to CE is not reachable.Int he same network If there is only one P router then it's working fine.Can anyone sugges...

I will do some searching on my own, but does anyone have a really good design and operation doc for MPLS that they have read and are familiar with?Something that I could sink my teeth into. Something that gives scenarios of different implementations ...

I had a multi-VRF Multicast configuration going using the following document for configuration:http://www.cisco.com/en/US/technologies/tk648/tk828/tk363/technologies_white_paper0900aecd8012033f.htmlI rebooted both routers that peered via iBGP after a...

Hi,I have a setup where 7606s are connected over an STM-1 SPA interface, following QoS is configured.Class Maps:-Ingress (UNI Interface):class-map match-any Gold match ip precedence 4 class-map match-any Bronze match ip precedence 0 1 class-map mat...

Anybody know ? Could it possible to configure load-balance Traffic between CBTS Master Tunnel? Im not sure that CBTS Master Tunnel load-balance supported by cisco.