Network Management

When I upgrade a switch or add a new switch into our network CS, RME and DFM detect perfectly the switch but under Campus manager the device is detected and it also has appears under the list of devices with successful data collection but when I go t...

Hello all,I have problems with Syslog which are not received in WUG, I think this is because RME get them with 162 port, Wht Can i do to receive them on WUG??Then, Ciscoview doesn't give me the card SupII+TS et X4124 of my 4503, and I 've got pb with...

When I run the Credential Verification Report, several devices are listed in the "Devices for which credential not verified" section. What does this mean?ThanksJamie

is this behaviour correct or is this a bug?:LMS 2.6 on solaris(but I think it is the same with LMS 2.5.1 and below)if the LMS installation is not done in the default location, a link is created as /opt/CSCOpx that points to the customer choosen insta...

I am running Network Registrar 6.1.3. I have 12 subnets that I am using DHCP. If I have a PC that is defective that is in another subnet, I usually go into that device and do a "ipconfig /release" to release the ip address. I then bring it back to...

Just started playing with CiscoWorks, I'm trying to add all of our devices but can only seem to add them one at a time. Is there a way of making it run through a whole subnet and adding any device it finds?

Hi Forum,How do I measure the utilization of my switches and routers. How do I know that they are over-utilized/congested?My SAP users are claiming that traffic over the WAN link is slow, they use mercury loadrunner to perform the test, How do I cros...

Can anyone suggest a method to determine if a switch port has been inacitve for a period of time? As an example, a switch port in a telecom closet might be cross connected to a workstation, but if the local workstation team is not diligent in removi...

Afternoon all.I'm tinkering with RADIUS at the moment and I'm trying to figure out how to do something. What I've got currently is under Microsoft IAS, I have 2 policy's defined for L1 and L15 access. This all works great I can add and remove groups ...

Hello,Does CiscoWorks have any kind of NTP capabilities? What I would like to do is point all my switches to the CWS to keep things centralized, while pointing the CWS itself to my NTP server. Is this feasible or just bad news all around (if it's eve...

Hi, I have a display problem since I have configured the LMS 2.6 to authenticate with ACS 4.0 I can't access the topology map, path analysis, VLAN Port Assignment, i have the following errors message "Your session has either timed out or you are not ...

Hello,when I check the collection status of the Iventory (RME - Devices - Inventroy - View Inventory Collection Status)Devices for which Inventory has never been collected.an information will be display: 50 records (Device name = VLAN IP addresses of...