Network Management

When I run the job for inventory collection some of my devices fail witht he error "Device Collection Failed" I see these devices are fully managed in RME, I'm able to verify credential and able to run netconfig job for these devices but fail in inve...

What does the locIfLastOut value of -1 mean ?ffu@dk.ibm.com

Hi,When I 'Check Device Attributes' for Telnet/Tacacs/Tacacs Enable it says NOT SUPPORTED.For C3550 and Catalyst 4003.I have RME 3.3, any ideas?!?!Thanks in advance.

Is there a way to have the ld417 to just direc to SERVER A if SERVER B Fains?

Dear All I use campus manager 4.0.4, The User Tacking always status = Running . And many end host found (1758400 end hosts) I think it wrong. How to stop and start user tacking by manual? How to debug the process ? ThanksIttipol.c

I'm getting the following error when trying to delete some "Non Reponding" devices. There are about 40 devices that give this error every time I try to delete them..Any ideas?Are there any database management/tidyup tools I can run, or should be runn...

which IOS supports netmask 255.255.255.254

hi!! i really new to cisco works......actually iw ant to know what that is and which version shd i get to configure my routers in network by using cisco works.....there are lot of cisco works software....which perticular i have to get inorder to conf...

We're running the 2116 appliance and Cisco 837 routers running 12.3.8T6 IP/FW/3DES code, and I'm having a horrible time creating my first cns router configs. I have enough created that when the 837 boots up, it successfully retrieves the initial conf...

I am planning a LMS 2.5 installation and have a question about the following.I want to use two syslog servers (for redundancy) and have configured my devices accordingly. I have read that you can use the Remote Syslog Collector from RME to pass on th...

Hi, collegues.I have the following problem after integrating LMS 2.5.1 with ACS. All the devices on the topology map of CAmpus manager are red and marked "unreachable". The problem solves after changing from ACS-module to local-auth module and then a...

Hi mates :)LMS 2.5 recognizes and manages all cisco active devices within the network. But my PC (NMS server) which runs LMS 2.5 is shown "failed device" on RME/config mgmt/config archival status. Only IP address of PC (LMS2.5 server) is visible. I k...

Hi,I want get Object Id for cisco devices because I want to configure MRTG for my router Traffic .I want configure CPU Utlization Graph of 7206 VXR . for this i need OID .Please help me by forwading any link from i get OID.Regards