03-30-2012 10:21 AM
Hello,
in IPM we would like to add a collector with an Cisco 1841 as the source. The device is listed and automatically imported in IPM from DCR. When i add the collector the status is always "Source Not Responding "
Does LMS use other ports then SNMP /SSH to configure IPSLA on the device?
IOS on the 8141 is: C1841-ADVSECURITYK9-M
Any hints are much appreciated. Thank you
Regards,
C.
Solved! Go to Solution.
04-01-2012 03:20 AM
IPM uses SNMP RW to configure.
The device config must contain 'ip sla responder'
Cheers,
Michel
04-01-2012 03:20 AM
IPM uses SNMP RW to configure.
The device config must contain 'ip sla responder'
Cheers,
Michel
04-02-2012 01:59 AM
Hi Michel,
thank you for your respone. On the source device i only have the command:
ip sla monitor responder
But i still get the error above.
Cheers,
Christian
04-03-2012 06:41 AM
Hi,
thank you that did the trick. The reason why it didn´t work was a firewoll still blocking the snmp-write from LMS.
Cheers,
Christian
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide