ISDN E1 PRI VOIP

[jimihendrix1]

I am configuring an ISDN E1 PRI Connection

(1/2 Port Channelized T1/E1 PRI Network Module)

When I configure the E1 controller example add the framing and pri-group timelots in the E1 controller. The voice port {voice-port 1/0:15 in my case}is not created for me to point my pots dial-peers.when I do a show voice port summary its not shown but when i do a show ip interface brief serial 1/0:15 is up. The conclusion is its not creating the voice port after I have entered the pri-group timeslots command. Please help. Thanks

[jimihendrix1]

Your are right!Thank you so much Nick for your help. I truly am a big fan. Could you recommend a replacement part number. I assume I should go for NM-HDV2-2T1/E1 any suggestions.

[Nicholas Matthews · Accepted solution]

I wouldn't go with the NM-HDV, they use an older model DSP.

I would stick with straight PVMD2-X and VWIC-T1 cards.

hth,

nick

[jimihendrix1]

Nick do you suggest VWIC-2MFT-E1

[Nicholas Matthews · Accepted solution]

Yes, it's a standard card with full feature support.

[jimihendrix1]

Thank you once again for your support Nick.