Other Network Architecture Subjects

Can anyone tell me if there are any benefits in upgrading from an 806 to a 831? I currently have an 806 for my DSL conneciton which I'm happy with but have the chance of getting an 831 at a discount trough the Cisco Academy. The one thing I like abou...

I'm planning to activate RMON in 6509 switch with 7.4(3) CAT OS. Do I need to purchase seperate license to able RMON function and if yes then what is the product code for RMON license.Thank you in advance.

I have CISCO AS5300 with E1 lines and it is configured for modems. I want to dial in to my AS5300 from ISDN BRI (Router and Terminal Adapter).Please send me the configuration to congiure the CISCO AS5300 for ISDN BRI and async modems dial in.I will b...

Is there a way to back out the changes made to the config of the cat 5000?Thanks.

Doe's the Catalyst-4507R (sup-IV) support the following RFC'S:- RFC2474.- RFC2597.- RFC2598.- RFC3140.- RFC2697.- RFC2698.

Can an 831 be connected to both a Cable Modem ( primary ) and DsL connection ( failover ) to customer's VPN? If so, how?Thanks,Dave

We currently have (4) 2524 routers on our WAN with built in CSU/DSU. The current IOS is 11.1 and I would like to know what (GD) of IOS can I go to.If I move to a higher level of IOS will this allow me to run Netflow?ThanksGreg

HiI have managed to get all my clients internet access through my Cisco1720 then through my RequestDSL router/modem to the internet using NAT overloading.However, i need to get access from the internet to my mail server and various other ports on my ...

LMS 2.1======I am using the DFM mail notifier to receive events seen by DFM, via email.If any RMON events are seen by RTM, I would also like them to be emailed to me. From the DFM docs, it looks like DFM does not process or pass through RMON events (...

We have Cat 5000 switches with RSM and I am looking for docs as to how to assign a VLAN to the RSM. Can someone please point me there?Thanks._ Alex

I need to add some Ethernet ports to a 3640, for new connections to a WAN provider. In looking at these two modules, it would seem either one could work, but the switch card is about half the cost. Why would 16 ports cost less than 4? Are there some ...

This is my first exposure to DROP and INSERT configs. Same T1. Voice and data. VWIC-2MFT-T1-DI module.Looks too simple. One T1 controller to the service provider, the other T1 controller to the PBX. Cross-connected with the "connect" command.Am ...

We are using CiscoWorks Topology Services to detect speed and duplex mismatches in our network. Unfortunately, some duplex mismatches are going undetected by the software due to one side of the link showing an "unknown-duplex". After further inspec...

Where can I get more info on the following error:May 4 18:11:11: %C4K_IPROUTEMAN-3-FIBADJMANDUPLICATEADJ: FIB Entry: Tried to create a duplicate adj for key 192.218.223.76/20May 4 18:11:11: %C4K_IOSIPROUTEMAN-3-ADJMANNOMOREADJS: AdjMan: hardware ad...