Other Security Subjects

Hello experts,i have a strange issue on a link between two ASA5510: both ASAs are interconnected by a P2P Fastethernet link, and the traffic between both ASAs is being secured by a L2L IPsec tunnel. The configured MTUs are 1500, however packets bigge...

HI All,Browser cannot permits next step for upgrade phone version via HTTPs. We need to Upgrade Phones without HTTP browser.We get file into tftp but we cannot install to .loads filesadmin:file list tftp /cmterm-7941_7961-sip.9-0-3.cop.sgn How can i ...

I've installed version 4.8.02.0010 of the VPN client onto a Dell Latitude D820 laptop. When I attempt to connect, I get this message. There are no firewalls running (I disabled the Windows XP firewall) and I'm running under Service Pack 2 with all of...

We are looking for a solution to avoid VPNs to encrypt data between HQ and Bldgs (point-to-multipoint) Gigabit fiber(untrusted media).Is there any cisco's product providing layer2 encryption over Giga fiber?The HQ has a 6509s and remote bldgs have mi...

I have been net searching this question and I find answers relative to other Cisco products but not for the 6500 series. We are running entservicesk9_wan-mz.122-18.SXF17a.bin and would like to know how to change the default SSH listening port..Thanks...

Hello all,We've setup NAC as Out-Of-Band Real IP Gateway. We did the test from a L3 adjacent client.It's working when login from a web. The user is listed under online OOB user, the pc gets an IP address on the vlan assigned to the user role.We'd lik...

Hi AllIf a PC had the the CSA Agent installed and working properly, but after a certain time it was formatted and the CSA agent was not installed again.Is there a way to detect that from the CSA-CM?Like can we detect/generate report of Agents that ha...

In a scenario, there are Two firewalls that are connected to two core switches, I want to place IPS sensor inline with Firewall and core switch, but I have only One IPS.Can i connect in this way? Or is it mandatory to have two IPS?

I am setting up a gre tunnel between two remote sites for backup for management T1's. I have the tunnel set up with the correct source and destination and can ping both ways and eigrp is set up correctly and I can see the neighbor relationship. But...

Hello,> > i got this message:> > [InterScan for CSC SSM Notification] License Violation> > License violation has been detected on the InterScan for CSC SSM. There> are currently 101 active nodes while you only have 100 seats of license. 1> more seats...

I am dealing with an incredibly fun PCI audit and i am in need of somehow generating a report that shows all the devices that the CSMARS monitors.  Is this possible?

Hello everybody.I went through all discussions regarding how to block access to some web sites. And I was trying to implement them but it didn't work.I've used 887G-3G-K9 router and UC540, and I'm not sure if it's possible to do that on them or I nee...

Hi,I would like to know how to fix these Vulnerabilities.1st set is for Cisco IOS (Version 12.2(35)SE5).1)SSH Weak Cipher Used2)SSH Protocol Version 1 Supported3)X.509 Certificate MD5 Signature Collision Vulnerability4)SSL Certificate - Signature Ver...

Good Day Everyone,I got the CS-MARS IPS-SIG Ver 577 from the cisco Site, I started thoe update around 24 Hours ago and as of now when i click on "Update Now" it gives me an error saying " System is already in the Process of downloading and upgrading ...