Routing

I am installing a new site overseas. I have ordered 2 T1/E1 circuits between us, which will terminate on 2 different routers at each end. Per the carrier the circuits will be layer3 MPLS.(Which i just found out a minute ago) but they can be changed t...

what is exact use of "ignore-dcd"?is it good to use or not this command on serial interface?dporter

Hello,I've been searching for router that can replace the obsolate 1720 that we have. I've started another post asking question about 837 router, but now my questions are about 877 or the 1800 series. The links to the ather post, in case that can hel...

I work for a company that has a fully meshed wan. I'd like to setup a test network at my house. I have a verzon dsl business account. Is it possible to setup something that would be similar to my work environment to test new apps, os's, etc?

Hi,Can i use 1721 for IP telephone & Data.? If yes than what is IOS Part#. If not then which 1700 model and what IOS support Ip telephony and Data.?Also which router is compatible for MPLS?regardssk

I've had no experience with Cisco Routers so pardon my ignorance. I'm attempting to add a network address translation to my router so that traffic to a certain IP will go to my firewall. When I do a "show running-config" I see where all my other NATS...

Hi,Iam in a process of shifting the Links from Riverstone switch to cisco 6509.When i was shifting the Links, one link was not comming up.Here it is.I have configured in Fa4/1 asinterface FastEthernet4/1 load-interval 60 shutdown switchport switchpor...

Hi is it recommended to have a DMZ Vlan? What I mean is, if I have a switch on the outside interface of a pix and a switch on the DMZ interface can I just use unused ports on the outside switch i.e. create a VLAN with serveral ports in the DMZ. I k...

HiThe 6509 series switch is new to me. It is currently running Cisco IOS on the supervisor module and CatOs on the switching modules.If I want to upgrade to Cisco IOS (on the switching module) the Software Upgrade advisor on Cisco.com tells me that ...

I just recently bought a couple 2612s for a home lab. My intentions was to use one to route between VLANs. I can get into a subinterface of e0/0, but I cannot configure encapsulation. Can I create a VLAN interface on a 2612?Thanks!

we having 512k interlink ,now we will be going for backup internet link from different service provider .The backup link should autommatically come up when the primary link goes down and web mail server should be active when the back up link active....

I have a cisco1841, i have created 2 ipsec tunnel to branch sites, & its working fine, but i discoved the form hub to spoke its working fine but from spoke to spoke its not working, & it became worse when i added Cisco VPN clients to the network as ...

I configure ATM interface on Cisco 2800 router series, I perform the following steps1. Enable controller for ATM interface 2. Configure IP Address for ATM 0/0/03. Creating PVC and mapping protocol Address But my ATM interface still shut down. I check...

HiPS Throw light to the following Scenario:an internet router connected to the ISP,WE Recently removed the ISA And replaced pix firewall with 3 interface. interface 1 of the pix connected to the internet router via a cross cable.interface 2(10.100....