Storage Networking

Dear All,I use two MDS 9124s to connect each other by ISL.I use Fabric Manager to edit Zoning Configuration, and save it.I found only one switch has zoning config by "show run", another switch does not have consistent zoning config.Is it possible we ...

I need to statically route traffic between two switches (both MDS9513 running NxOS 4), across different FCIP links, depending on source and destination- VSAN 500 exists across both switches- both FCIP links are part of FCIP 500- VSAN 500 is allowed a...

Hi,I have MDS and Brocade switch in the network scenario , suppose i have configured MDS 9124 with VSAN  and all the port licensed ports in MDS which are connected to BROCADE switch and also i am using Interop Mode 3 , so what configuration parameter...

We are trying to install Cisco Fabric Manager for MDS9000 Famliy Rel. 5.0(4c) on a Windows 2008_R2_SP2 machine, running java version 1.6.0_24 .While installing PostgreSQL8.2 we get an error:  “Failed to run initdb: -1073741502"  (see attached file fo...

Hi, sorry for my English, but I hope you understand me, and I understand your answers:) We are in the process of adding new data center (DC2), which will be geographically located about 20 km from our existing data center (DC1). Between them laid dar...

Does anybody know how to reset the 'Run' and 'Pass'  counts shown in the sh system health statistics display. A number of our switches now have modules were the count has passed 9999999 so the 2 columns are merging into 1, this is causing our healthc...

I am in the designing stages of a data center where we want to use NEXUS 5000s, NETApps 3140s and NEXUS 2232s for FC0E. From my understanding these devices inter operate like so:Servers will have converged NICS that use normal CAT 6 to connect to the...

Hellofor Tests I need iSCSI Driver Version 3.4.5 for IBM AIX 5.1 aund  HPUX 11.1 which are out off support and not avaiable on Cisco Side anymoreCan you help meBest RegardsReinhold Flecke