Hi all, I just would like to ask help from anyone here in the forum. Here's the log or find attached. `show module internal exceptionlog`********* Exception info for module 1 ******** exception information --- exception instance 1 ----Module Slot Num...
hey folks,I have experience with EMC storage arrays and McData/Brocade directors and switches...but, i'm lacking any knowledge of the MDS9000 series fiber directors and more specifically, the HDS storage arrays...What software is used to manage the H...
Hello,I'm wondering if there are ways to automate the backup of the zones and zoneset that you can perform with the fabric manager GUI?maybe through the CLI?many thanksEric
hi,we have 2 9513s and 2 9509s in our environment recently I saw one of the port was disabling because of bit error threshold. temporarily I made the port to ignore the bit errors in the cli.will this lead to any other issue ?now when I clear the er...
hi folks, new to the MDS9500 series directors...so i'm going to ask some basic questions.Currently have 2 switches. I've inherited this issue, they are attached to HDS arrays. one switch shows the HDS FA's, but the other does not.I'm assuming, it h...
hellocustomer trying to close zone under FMand received following error messageany advice welcomed i didnt find any reference in documentationJYPSNMP: Zone: Duplicate member - RWSE-02A ZoneAliasList .1401.7
I am brand new to the fabric switch world and until now have only had experience with ethernet switches. I take care of the network infrastructure where I work and have been tasked with documenting a backup/recovery procedure for our fabric switches ...
Guys:Config info:I have a HP C class blade enclosure, with 2 new 9124e's in it. I need to activate it,and figure on doing the following:Define 2 T ports on the 9124e, and connect them, to 2 Fx ports on the 9509.(1 9124 to each 9509 for redundancy)He...
I currently have 1 switch at our two buildings connected via dark fiber. They use one port for ISL between the two sites. I now need to add an additional switch at each site into the same fabric.I think it would make sense to connect say, port 1 from...
Dear Support, need your help to fix my setting. I have bought now the good 10GBFC Module for connexion between MDS C9134 and C9222i. the trunking is OK between the 2 switches. But we have Vsan with zone on each MDS but they cannot communicate. Please...