VPN

Hi,Im about to take on the long overdue task of upgrading the software on our VPN Concentrators.I think im ok with the upgrade procedure but its the regression/backout thats has me concerned.If there are issue after i upgrade how do i back it out bac...

I am looking as SSL and note that it is diffcult (or impossible) for ASA 5510 to support Vista by using SSL is it is running verion 7.x software. It needs to be updated to version 8.x.Looking at the website of sotware downloads - there are several to...

Hi;Yes this an old 506 vpn question.My old 506e running version 6.2(1) failed and was able to find another one.  I had the config file so I just dropped it into the other 506e and was up and running in no time.However I cannot connect via a VPN conne...

I have the following networkNewmarket LAN 200.0.0.0/24 - inside network connected to interface "inside"Connection to ISP 1 - 217.37.175.6 - interface "outside"connection to ISP 2 - 88.96.81.97 - interface "backup"I am trying to build a VPN tunnel usi...

I have been trying to install by using the suto web install but that fails. I have downloaded the manual installation package for XP and installed. It immediatly crashed when I logged in. I have tried a few times and have logged in using the VPN clie...

Hi i`ve a problem with initiating a l2tp session over ipsec from a windows client.Here the tunnel i`ve created:ciscoasa(config)# crypto ipsec transform-set l2tp_transform esp-3desciscoasa(config)# crypto ipsec transform-set l2tp_transform mode transp...

i`m frustrated i`m not getting this working and i don`t know why. Have created a default route ( route outside 0 0 <outside gateway ip> and i`m not able to connect to the internet from inside hosts. From asa i`m able to ping internet adresses.I`ve pl...

We have configured the VPN Server on a router Cisco 2821. After configuring the Cisco VPN Client we can stablish the tunnel (the client receives the correct ip address and there are the secure routes configured properly). But from VPN client we canno...

Hello,I have a user on my network that took his system home to use it the other night.He had the PC running in one room and the VPN was up and working normally.He unplugged the network cable to move the PC to another room, at that pointthe system hun...

I have a site-to-site ipsec tunnel connection set up between two sites using asa 5520s.  At our main site, all outbound traffic is pat'ed to it's outside interface address, excluding site-to-site ipsec tunnel traffic.  The secondary site tunnels all ...

I have an ASA 5505 configured for AnyConnect Remote Vpn access. Vpn users get ip addresses in the 192.168.10.0 network and the inside network is 192.168.1.0. I have followed the instructions from http://www.ciscohelp.info/en/US/products/ps6120/produc...

I have a DMVPN AES/GRE IPSec VPN setup between a 2811 router at my remote site and a 2851 router at my host site.  The ethernet ports on each router connect to a wireless network that has 54 Mbits of capacity. The problem I am having is that my encry...