I would like to setup a site to site VPN between ASA5510 and Linksys Befvp41. I have tried almost one month,it seems unsuccess. Any one have this experience? Please kindly advise. Thanks a lot.
Hi,My Clientless SSL VPN users only connect to my ASA on RC4 protocol encryption, is this ok? I want them to connect on AES 256 but they can't.Actually 3DES-168 seems to work as well.Thanks
Hello,I have Pix 515E PIX Version 6.2(2).I am trying to setup easy VPN server on it. This pix did not recognised the following comand line.1.crypto dynamic-map outside_dyn_map 70 set reverse-route2.crypto isakmp nat-traversal 70or isakmp nat-traver...
I have an pstn line attached to an fxo port. However voicemail from telco only works when line is off hook when it is on hook it just continues ringing. Can you assist me please
I've been asked to setup a 2811 router with 2 DSL connections into an ISP. The customer wants to load balance across the 2 outbound circuits, which I planned to do using 2 equal cost default routes. They also need to NAT/PAT the outbound traffic.Sett...
I have a 2801 talking to a 2851 with GRE/IPSec tunnels. The 2851 has an AIM-VPN/SSL-2, while the 2801 is using the onboard VPN module. The max throughput I am able to see with qcheck or ftp is 10mbps, regardless of the encryption used. If I remove th...
We're considering deployment of about 50 1800s across the branch infrastructure with 3mb/768k DSL as the VPN port (DS3 head-end). DMVPN topology.Problem is that performance doesn't seem to meet spec in the lab. Spec says a 2800 should get about 50m...
i have one global ip address x.x.188.5 and I have to servers 192.168.1.219 and 192.168.1.220. I want to advertise these servers over the Internet on the following HTTPS & SSH.How can i advertise these servers with one global IP address. Please help m...
Hi,My iPhone can establish a isakmp session and get an IP address etc with my IOS 12.4 VPN on a cisco 2811.However, when I try and pass traffic, the phase 2 ipsec connection terminates the tunnel.I get error likeIPSec policy invalidated proposalJul 3...
Hi All, I have two site. in the main site, there are two vlan, voice and data which it is easy VPN server. in the remote site, there is easy VPN client. From the remote site, I only have connectivity to data vlan in the main site and there is no VPN ...
I am fairly new to the PIX and have spun my wheels long enough. I have a L2L VPN tunnel set up between a PIX 506 and a PIX 525. The PIX 506 is running 6.2(2) of the PIX OS and is the remote peer. The PIX 525 is running 7.2(3). The tunnel is up be...
I am trying to create an L2L connection from a 3K5 Concentrator to a vendor with a Checkpoint NGR55. At implementation this morning, we were able to access all NATed applications on their side, they weren't able to access ours. The message we saw on ...
Hi,Hope you can help. I need to allow a user access to one host on my LAN and only RDP access. I have a Cisco 2801 with IOS 12.4. VPN is working great for other users. Is there a command that i can apply to a crytpo map or the likes to restrict certa...
We have a requirement to terminate an IPsec tunnel to the inside interface of a 515. Is this possible? I have never done this, so I want to make sure. How about asa?
