VPN

All,Code7.2(2)H/W: 535What's the default behavior for Reverse Route Injection ( RRI ) for L2L VPNs ?The reason I am asking is because when I add the following:!!crypto map OUT-Map 100 set peer 1.1.1.1 !crypto map OUT-Map 100 set transform-set Corpora...

When I connect to my VPN client on Windows XP I have problems witch acces my local network.i can not print anything when I am connected and Ins my external hard drive is changing names (K, L, M) when I connect.both (printer and hard drive) are connec...

I have a project where several PDAs are going to be synching data with my network over dial-up. I have a 2811 router and purchased a HWIC-1CE1T1-PRI card and a PVDM2-24DM module and I have installed them. Can someone point me in the right direction...

I have a client that is running Win2003 Server R2 with Exchange Server 2003. OWA was setup and clients could connect to their exchange mailbox from the internet with no problems. We recently configured vpn on the ASA 5505 and now no-one can connect t...

ssh configured on router by following commandip domain namehostnamecrypto key generate rsa1024while logging by ssh it shows some message likersa fingerprint nc.ht.---------------------------------connect yes/no ?should i proceed or varify the key ?if...

I have a concentrator 3005 with a inside interface directly connected to a vpn etherenet interface on a PIX 515e. If I ping the inside ip of the concentrator 192.168.1.2 I expience latency. 1-30ms. I so see a lot of FCS errors on the inside interface...

Is it possible to record the mac address of the connecting Cisco vpn clients? I have mixed 3030's & ASA 5550's as entry points.Thanks in advance.

How can I assign an ACL to an existing LAN-2-LAN tunnel. I want to limit traffic through the tunnel down to a specific IP address and TCP port?

Hello,I'm looking for configuration assistance in regards to migrating a production C7301 router to a pair of C7201 routers for L2TP tunnel termination. The existing C7301 terminates L2TPv2 tunnels from wireless access points with embedded cable mode...

I am planning for DMVPN deployment where the hub router is going to be directly connected to the Internet while spokes will reside behind firewalls (PIX 501s). I would like spokes to do just the multipoint GRE and offload encryption to firewalls. The...

ASA5510 active/standby failover.we have two ASA 5510.appliance 1Maximum Physical Interfaces : UnlimitedMaximum VLANs : 25Inside Hosts : UnlimitedFailover : Active/StandbyVPN-DES : En...

Have problems downloading ftp files through the firewall

We have site to site ipsec vpn its works fine but when i clear the isakmp peer its was clear.then i try to start interesting traffic again for initiating ipsec tunnel i found decaps/encaps packet with no errors but i dont see any qm_idle peer on sa s...