The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
Dear Gents, What are the recommendations that should be followed if we have a local site with wireless APs operating in Local Mode and registering on a local Primary WLC on the same network. and in the case of Primary WLC failure, the APs w...
Hi everyone, Currently, I've been using the Interface NAT type for Direct Internet Access (DIA) across multiple networks. However, I recently came across a Cisco article (Below link) suggesting the utilization of a Loopback interface for DIA ins...
When I connect to the switch(2960x) for the first time with the console, I get the following error and I cannot enter any commandError opening tftp://IP/ios name.bin (Time outThank you for helping me
We are trying to set-up A9K-8HG-FLEX-TR in the ASR-9906 chassis with redundant A9K-RSP880-LT-TR and running IOS XR 7.9.3, but after about 2 hours the module is still in the SW_INACTIVE state. All the lights on the module are amber color, but it does...
I have a FirePower 1100 for my home lab and for some reason, it lost DNS connectivity and lost registration. I did not notice and now I can't deploy changes. I connected to the CLI and tried to ping from system. When I try to ping from system I get t...
Hi all, I have a cbs350-8p-e-2g with version 3.4.0.17, every time to reload it will show below message but I didn't make any configuration changes. Is it a bug ?"You haven't saved your changes. Are you sure you want to continue ?"
So I cant make my 2 laptops and 2 smartphones conect to my wireless device if it has WPA2-Enterprise Security. I don't know why it happens because when I eliminate the security it connects perfectly. Here's the .pkt if anyone can figure it out why
Hi Guys n Gals,I am having a bit of trouble with an assignment I am doing in packet tracer.I don't have the files handy until the eve, so will send pics/files later if required.My problem is that I have an access router connected to 3 separate cluste...
HelloAfter I have setted every policy on the switch and everything is working fine through an ISE authentification via dot1x, now server cannot reach its gateway in order to give IP DHCP addresses to the hosts on VLANs!Can anyone help me please
Hi, We have installed Aironet-1562i-outdoor-access-point one of my project, While installation it was getting power from the 4506-E Switch and it was registered with Wireless LAN Controller, but now the Access point is not getting power from the swit...
Does a WLC support bridging mDNS between wired LANs only? More accurately, will it respond with mDNS service provider info learnt from wired LANs to mDNS queries coming from wired devices in other LANs? I had assumed so, but debugging today I'm seein...
Hi, I'm looking to get some assistance or guidance on this old phone system. Looking to see if there's any 3rd party vendor that is willing to help troubleshoot some issues. Cisco Unity Connection version 8.5.1ES65.13900-65Cisco Unified CM Administra...
HelloSo I configured my RA configuration on my FPR1010 for access to my LAN 192.168.5.0/24 but was curious how exactly would I allow this on my ISR to let me connect to it? Not exactly sure which Ports would be needed opened