Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Is it possible to get info on changes made to the system by user and time on CUCM v5.1
Hi there,I will have a CCM 5.x and CCM 7.x in parallel. I will migrate user on the 7.x.I'm asking me, when I install 7.x do I have to know what patches have been applied on the 5.x so I will install them on 7.x too ( in case 7.x did'nt fix it ) if y...
I have a network with a UC500 connected to a 3750 switch going through an ASA.The ISP is currently having problem, so the site will be offline overnight.I have no experience with VoIP, so will this be a problem in the morning? When the WAN comes bac...
Hello,Is there a way to have CUCM automatically insert the special characters around the phone numbers in active directory, so that when a user searches for someone in corporate directory the numbers shows as (555)555-5555 instead of 5555555555??We c...
I have looked at a couple posts on my issues and cannot narrow mine down. Inbound calls to FXO fail basically. I used CCA to configure and inbound calls were first plar'ed to the AA. The call comes in and once tranferred to AA the call disconnects...
Get the following error while trying to upgrade to 7.1.2 Downloaded from Cisco's web site, and am doing local install. It detects the file, then hit next and get "The version number inside the selected upgrade does not match the filename"thanks
Hi peopleI am running the Dirt to 1108 mailboxes (W2k + Unity 4.0.5 + Exchange 2k). On 33 minutes, 869 mailboxes was copied. But on mailbox number 870 (Example Administrator), the copies were slow. Until this record was being used in HD 2gb, after t...
I am forwarding calls that are unanswered from one ext to another which is working fine. The forwarded calls are not going to voicemail on the destination extension. Does an "Alternate Extension" else need to be configured in the SA Web portion to al...
Hi allI am trying to run subscriber reports and I get a message saying that it has queued. When I look in the commserver\reports I cannot see the fileAny ideasThanks
Is there a way to block certain incoming numbers on call manager from getting through to specific DDI's? I know you can do this on the gateway but I want to know if it is possible to do this from within call manager version 4.1(3)Scenario - nuisance ...
Hi,I've changed the IP Address of the Unity Connection Server but it seems the IP Address on the Connection Location page does not change. Does this matter? I am trying to network two Unity Connection servers with the same hostname but in different d...
I have a new install of a CCM 7.0(1) running in a lab on a VMware server. Also installed is a Unity VM 7.0(2) running in VMware. When you dial the VM pilot number (7000) you reach Unity. When the Messages button is pressed on an IP phone this mess...
many people asking about the requirements of the cables to support IPT.So, Is there any recommendation from cisco regarding the cables like:( Do not use IPT and PoE with Cat5 cables)????
Sorry if this has been discussed, but my search only brought up Unity unified messaging posts.I currently have unity 5.0 voicemail only.We recently moved to Exchange 2007, and are licensed for the new "Unified Messaging" feature in Exchange. I am lo...
Hi to all,How can I configure auto attendant with cisco unity connection 7.Best regards,Alberto
