MPLS

I did it couple of times but it didnt work. I am just trying to build MPLS L3 VPN with OSPF as the PE-CE protocol, EIGRP running within the MPLS cloud and PE-PE protocol being MP-BGP. PE router perform mutual redistribution and the routing table at C...

I have a client who wants to do some MPLS. While I feel I have a good understand of the concept of MPLS, I currently lack the knowledge and experience to know how to properly design it.The client has 2 7200s and 2 3560s in POP1 and another 7200 and ...

Hi Can someone tell me if PBT would replace MPLS soon? If so how soon?

Hi Everyone. I recently did an IOS upgrade from 12.2(18)SXF4 to 12.2(33)SRB1 on a 7609 MPLS PE Router. No config changes were done. However, after the upgrade, some OSPF and static routes for some VRFs went missing. Has anyone ever encountered suc...

I am looking to implement SNMP-based monitoring of an MPLS layer-2 tunnel. The desired result would be the same as the output from the following command:"sh mpls l2transport vc"I have configured the router to generate SNMP traps based on LDP changes,...

Hi I look for informatiom about MPLS network with 2 different S. Provider connection with each CPE . For redundancy. VPN and voice is a requirement. Anybody knows where can I find information, tips or exemples ? TIA

Hi folks,my topology is like that:vlan 30 - router A & B - mpls cloud (no vlans) - router C & D - vlan 30I've created two xconnect tunnels (A-C and B-D), but the first is working, the second is for a cold backup.How could I use both at the same time?...

I am looking to implement SNMP-based monitoring of an MPLS layer-2 tunnel. The desired result would be the same as the output from the following command:"sh mpls l2transport vc"I have configured the router to generate SNMP traps based on LDP changes,...

Hi allBelow is my simple networkCE8--PE2---PE3---CE2 ( One VPN Green)I am running rip between PE and CE , attached are the configs for all Routers.Plus Ip route on the CE's and sh ip route vrf Green on both the PE's What i am doing wrong, please have...

refer to the artical of the link:http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a0080110be9.htmlI need some infomation about the data plane. when a packet go frome one side to the other,how did the frame format chan...

Hi:When this cmd. is enabled both on PE1 and PE2 across a MPLS core, why does the trace output show the egress PE2 router in the output?I have CE1->PE1->P->PE2->CE2.I am tracing to the lo0 of CE2 10.1.8.8PE1#conf tEnter configuration commands, one pe...

I am trying to leak specific routes between two VRF's using the following config. It filters one way, but doesn;t pass any routes the other. If I replace export map customer-mgt-range with route-target import 39097:701 then all routes get learnt. If ...