I upgraded my RME from 4.3 to 4.3.1 which broke functions in Device Center (CSCtc21648, is it possible to downgrade back to 4.3 or does anyone know the workaround?
Has anyone else experienced this issue? We upgraded to LMS 3.2 (windows server 2003) and the following morning around the time the devices are polled, about half of our CatOS 6509s got these excessive fragmentation DFM alerts. Nothing has changed on ...
I am now running LMS 3.2 and I can't get email notification to run to send me an alert nor when I run custom reports.Another issue is with contract connection it gives me an error. I still have my old ciscoworks server up with LMS 3.1 and it is runni...
HiI define some groups under "CampusManager" and under "CS-Common Services" and assign some devices to each group.Now I go to CommonServices-Device and Credentials-Device Summary. There I see the cs-group and the campus-group.When I click on it, I se...
LMS imdediate backup works but cannot schedule. Got message 'Cannot read schedule info. Please look into the log files' which log I should check?It did not work in 3.1 now upgraded to 3.2
We have CISCOWORKS Hosting Solutions Engine Version 1.9.We use it for SNMP statistics of our CSS 11000 series content switches.Recently we have been considering its use for managing the configurations of the CSS devices, especially simple changes suc...
We are attempting to upgrade some of our routers to a new image that is recommended to have a 128MB flash, but our routers only have the 64MB flash. The image is only around 58MB and loads without any problems via TFTP from a PC. However, RME will ...
y remote site customer has 3560 with 12.2(44)SE6, that if they run the command: conf net for a script: ! crypto key generate rsa general-keys modulus 1024 ! It said it is successful, however, the configuration is not applied. JSTA-MDF-s02#sh ip s...
Hi,I've installed sdm 2.5 on my PC and configured an 877W running c870-advsecurityk9-mz.124-24.T.bin with a very basic config just to get me going. I can use launch sdm via the launcher using http and it runs fine, allows me to make config changes an...
I'm troubleshooting why a few of my devices are being discovered by CS Discovery, however, they are not getting discovered by Data Collection, therefore, I'm not able to see them in Campus. Below is an error in topo.log file. Can you give me a hint...
I was wondering why usertracking in the current CW LMS 3.2 is not supported for firewalls (ASA, PIX, FWSM etc.).It wouldn't be to difficult I suppose to implement this, because it allready does the same for routers (reading arp and mac tables and com...
Hi,Since recent (LMS3.2) Cisco released the Open Database Schema support. In the guidelines I find info/procedures to access the database remotely via ODBC. However only Solaris/Solaris Windows/Windows is described. Is there any info how I can acce...
Hi all,I've been facing problems in getting inventory information from my WS-6509-E. I didn't find any device package regarding to this device model that could solve my problem. :(We have here a CWLMSV3.1(Windows) and RME4.2.I also attached a sh vers...
