Hello. Has anyone seen any performance issues when running LMS 3.1 on the T5220 servers. If so, can you tune Ciscoworks that is works better with the server.
Hi,does anybody know if an ios router can send traps if interface level rate-limit thresholds (like "rate-limit input access-group 110 3000000 10000 10000 conform-action transmit exceed-action drop") are exceeded?Am I right that the normal snmp agent...
Hi All,I dont now, Why my archive management not contains more than last 8 configurations. Previously it was contains last 77 config's.Is there any way that the old configurations saved or placed somewhere.It is my urgent task to complete as we have ...
Tare six questioned (?) devices in DFM, due to SNMP timeout, while five in Known state. I have changed the global SNMP timeout value in DFM to 10, but still these devices are not rediscovered. LMS v3.2DFM v3.2.0Please guide.
Hi,We are in the process of migrating our existing Ciscoworks LMS 3.2 serverto a new platform. We are going to be installing LMS on Solaris 10 and we'll beinstalling LMS into a whole-root non-global zone.1) Does Ciscoworks LMS 3.1 support Solaris 10...
When I run this report on one or any number of devices, the report has all zero's. However, if I run a 24hour report, there is obvious data. Thoughts?We're running LMS3.1, Windows ver, ACS integrated.
"CM0060 PRIMARY RUNNING Config fetch SUCCESS forwsd15231.netiss.intesabci.net, version number 3archived.CM0057 VLAN RUNNING Config fetch SUCCESS, archivalfailed for wsd15231.netiss.intesabci.net Cause: CM0012:Unable to create new version on archive $...
hi,has anyone encountered syslogs being sent to the lms server with a message:%ATM-3-FAILCREATEVC: ATM failed to create VC(VCD=0, VPI=255, VCI=255) on Interface ATM6/0/3, (Cause of the failure: VC is not an autovc.)we have noticed that this type of m...
LMS 3.2 on Solaris 10.I have several jobs scheduled with attachment option disabled. I get the email report and it says "Report Attachment is not enabled. Click the link following to enable the attachment option http://CiscoWorks.doaminname.com:1741/...
We have LMS 3.2 and on few devices the running config is not archived. the start up is archived and I have running config on device but RME unable pull that that running config. on version tree I can see on VLAN section the there is a running config ...
Hello,I want to configure S]MTP server on LMS v3.1 but it doesn't recognize my domain's name. An error shows up saying "Invalid IP Address or server name for mail server. Please enter a valid SMTP server name or leave the 'SMTP server' field blank".C...
Hi there,A few weeks ago I noticed that our 7206VXR routers could not be managed from Ciscoworks (devices were greyed out). This was no problem before. When I tried to reinstall (or even remove) the necessary device packages as part of my troubleshoo...
I'm trying to add some devices in RME that are physically located in china and behind the firewall. ping response is aboit 260 msec. I have opened up the necessary firewall for telnet but the config fetch/archive still fails with the telnet timeout. ...
