Network Management

Dear Netpros, When executing TRACEROUTE command on router(without giving source IP address)..then by-default which IP of that router/L3 switch is working as source address , If this ip is the router-id or highest IP address of that device then wha...

Dear all, i m getting the following error, how can i rectify thisTELNET: Failed to establish TELNET connection to 192.168.209.44 - Cause: Authentication failed on device 3 times. VLAN Config fetch is not supported using TFTP.Could not detect protoco...

I have created different groups of devices in DCR. But i am not able to see the devices in the topology views even if there is L2 connectivity within themselves.

Hi,I have a misatch of the devices in RME and DCR. There is noACS integration.DCR has 205 devices and RME has 201 and the auto mode is on for RME.CM after discovery show 900+ devices.What can be done please suggest !-Thanks

We have a master / slave cw2000 lms setup with devices showing up on the slave but I'd also like to see the netconfig jobs from the master on the slave system. Is there a way to import them to the slave system?

I would like to use the eem and a tcl script to check for any new files to download from a remote http server. The eem would be used as a scheduler to invoke the tcl script - which would access the http server and download any new files (what will be...

I have a terminal server that will not allow me to connect to devices configured on it. There are no other sessions or users on the terminal server at the time I am attempting to connect.Any ideas would be welcome.The configuraiton is attached, the e...

Hi All, I want to know where LMS 3.1 backs up the configuration of devices if backup is taken daily for some devices & weekly for some devices. In the shadow directory I can see only one configuration file per device. So where are other old backpu fi...

for a large Cisco environment. can someone point me to find best practice documentation and what tool to use. my company want to provide Network Performance Test & Health Check as a service.thank you for all your help

All,The install docs for CiscoWorks IPM 2.6 states that it will run on Solaris 8 or 9.Does anyone know if it will run on Solaris 10?Stephanie

Hi everyone! Been fighting an issue with LMS2.6 Topology services. When I open a topology map, all the icons are stacked in one spot. I can sort them all, but when I save the map, it doesn't save. If I close out of the application and re-open it, all...