Network Management

Hi,I'm using LMS 2.5, and using host file to resolve device names. Host file contains all device names in uppercase same as the device names. Is there any way to access devices either by name or IP(like Device Center) with either case. In RME/CONFIG/...

He Experts,can someone provide a real good recommendation, where I can go to LMS 2.6 class.I looking for a working class with explanation of all features based on working with it, I do not spend time for a CISCO powerpoint class, or a LMS release swi...

I am using LMS 2.5.1 Uer Tracking reporting tool. I am scheduling a weekly report, and sending an email with the report results.Unfortunately the email only includes if the report job has been successfully executed or not.Is it possible to send the c...

Is it possible to have a report listing VLANs that are configured on a group of selected switches?I am using LMS2.5.1.Thanks

Hi Folks!I've installed, on windows 2003 server, LMS 2.6 with CS 3.0.6 and DFM 2.0.10.I've syncrhonized DCR with DFM into DFM page, but into DFM I've 316 devices, while in DCR I've 339 devices.Anybody know how I can sysnc both DB?Thanks a lot!Leonar...

Is there a supported Antivirus product for LMS 3.0? I had Mcafee running, but it was giving me all kinds of issues. Is there a supported product, and is there any documentation that shows what is/is not supported?

Hi,I'm having a problem generating the syslog reports, where if either 24-hours or unexpected devices report type is selected with all the devices to run against after awhile (in about 2 - 3 min) I get the Tomcat error 500 with java.lang.StringIndexO...

I have a 4507 with Netflow. Am I correct in understanding that I can only see the flow of one interface? I want to try netflow but am moving cautiously and know there is a lot of traffic on this switch as it has 75+ servers connected.

I have verified that all software requirements have been met. However, when I attempt to import a Pix 6.3(5) config the status is stuck on "Importing" and does not complete. Has anyone experienced this and if so did you find a work around?

Hi, SirI ask question of SNMP's OID.Could you tell me SNMP's OID when use T1 module on Cisco 2811?PRI1 interface side : NormalOID:Index number:PRI1 interface side: AccidentOID:Index number:Platform:Cisco 2811Module:NM-1CE1T1-PRI Config:　card type t...

Questions:1. We are using IPM and need to send traps to a SNMP collector. We then need to process these traps for our paging/notification system. The traps we have seen to date do not give us much info from IPM. what are some common SNMP trap rec...

Hello,I want small help for the calculation of Bandwidth utilization calculation.I have read the cisco document but still I am confused with that as I'm not understanding the poll cycles interval.Help me with the formula too..Help me with these..Than...