Hi,I tried to access one of the devices in Topology Services in Cisco Prime thru SSH but was unsuccessful. How can I make it work? Do I need to install "putty" on the server just to make it work?Thanks in advance.
Have old LMS 4.x server, now built a new Prime 1.3 and transfered base license and 1500 lifecycle to prime server on a VMI am trying to now build the prime server from scratch. It seems that only the wireless portion is supported. Does prime 1.3 no...
HiWe have started using Cisco Prime for our network management. On our sites we have a few devices managed by other vendors which are non cisco devices, we would like to keep these in the diagrams on cisco prime but since we don't manage them we don'...
Hello All,We have a pair of 6509s (HSRP), and would like to check status of the backplane utilization.The "show catalyst6000 traffic-meter" command doesn't work - I get the "This Supervisor hardware revision has no support for traffic meter feature."...
Good day.It seems that Prime LMS builds a topology only by cdp, is it possible to use lldp for this purpose?Or any other method to see in topology none cisco devices?
I have written a simple EEM script to poll an OID which records the ADSL sync speed and generates a syslog if it falls below 4Mbit.event manager applet ADSL_SPEED event snmp oid 1.3.6.1.2.1.10.94.1.1.2.1.8.11 get-type exact entry-op lt entry-val "400...
Hi,I'm seeing regular virtual-access interface flaps. Is there a good way to keep a count of these? I could monitor the syslog and increment a counter however there must be a more elegant way to do this. I can't find an OID or show commands which giv...
I'm using Cacti to monitor our Nexus 5548UP devices. I can monitor the physical ports, and the Port Channels, but my layer 3 interfaces (vlans) I can not. Is this a limitation of the 5548 since it needs the daughter cards in order to do layer 3?TIA...
Hi ,I have some questions,Is it true that in the routers we need to install a software for NATing or the routers already have NATing feature by default? Also do all ASA firewalls have built in NATing and we simply have to enable it?---Posted by WebUs...
Hi Team,My goal is to achive that if the CPU utilization is greater than the 50% run the "undubug all" commandTo avoid the high tilization due to debug (I know that the access - list should be used for the same , but i want to achive this)Below is my...
Dears,I'm facing problem in the CPU Utilization on Cisco 3750x, the below is the resault of "show process cpu sorted": 5Sec 1Min 5Min TTY Process16.47% 16.93% 17.03% Hulc LED Process how i can minimze the...
I just have installed LMS 4.0.1 and have the following query. What is "Data Collection" in LMS and how does it differs from "Inventory Collection" ?What datas are collected from the devices being managed by LMS and what is the mode of collection? (SN...
I am working on a Prime LMS server and would like to get the reports off of the server. In the environment that Prime is currently running in, I do not have a mail server running. I was looking for a way to "copy" the reports off of the server and ...
